User manual AEG-ELECTROLUX ER7321D

[. . . ] Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. s s Installation s s s Service / Repair s There are working parts in this product which heat up. [. . . ] Push-fit the spacers into the openings, making sure that arrow (A) is positioned as per Fig. 2 and then turn the spacers through 45° until they lock in (arrow in vertical position). A 45° D039 Fig. 3 Door reversibility Unplug the appliance before carrying out any operation. 3) and slide the top door off the middle hinge. Remove the middle hinge, turn it through 180° and refit it on the opposite side (Fig. 4) after having removed the plugs which mask the holes. The plugs must be refitted in the holes left open on the opposite side. Unscrew the lefthand levelling foot, which will be refitted on the opposite side. Unscrew the right-hand levelling foot, the corresponding hinge and the stop and refit all these on the left-hand side (Fig. Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabine". If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabine". In that case, wait for the natural ftting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. D185 Fig. 6 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATIONS The technical data is indicated in the rating plate on the left side inside the appliance. 4 GB USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. GB Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: room temperature; how often the door is opened; the quantity of food stored; location of appliance. A medium setting is generally the most suitable. To stop operation, simply turn the thermostat knob to position «O». [. . . ] After two or three hours, reload the previously removed food into the compartment. Important: Fig. 10 D037 A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. 7 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: - unscrew the light cover securing screw . - unhook the moving part as show in the figure . Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorized technicians. Internal clearing Never use metal objects for clearing your appliance as it may get damaged. When performing a complete defrosting, wash the internal surfaces of the freezer with lukewarm water and bicarbonate; rinse and then accurately dry. Fig 11 External clearing Wash the outer body with lukewarm water and soap. [. . . ]