User manual AEG-ELECTROLUX ER7325D

[. . . ] Make sure that the cable is not trapped underneath the appliance, nor touches the motor. Repairs carried out by inexperienced persons may cause injuries or serious malfunctioning. Make sure the rear part of the appliance stands against a wall as there are working parts which heat up and should not be of easy access. Make sure that there is a continous and adequate ventilation as a failor to do so will result in component failure and possible food loss. [. . . ] Be careful not to lose the plastic ring. Unscrew the plastic bolts of the opposite side of the place of the central hinge taken out and introduce them in the holes occupied before by the hinge. Fig. 5 4 Changing the opening direction of doors and Panelling If you refrigerator has top panel, you can manage in the same way from point 1 to point 6 and then: 7. . . Unscrew the axle of the upper hing (9 Fig. 5) and replace it at the opposite side (10 Fig. Remove the lettle lid put on the opposite side of the central hinge and use it to cover the new holes left where the hinge was placed. Fig. 5 For the remaining parts proceed the other way round. Once finished make sure that all joints close perfectly well all around the door and chek that the internal light turns of when the fridge door closes. How to panel the doors If your appliance is provided with metal strips for panelling and you wish to do so proceed as follows: 1. . . Loosen the screws of the remaining strips. Start putting on the panel where you took off the strip pushing it right up to the end. Tighten all screws NOTE: The panel dimensions must be 2 mm. However, it may sometimes be necessary (due to poor ventilation, high roon temperature, frequent opening of the door. . . ) to graduate the setting of the «Temperature Regulator». In case of an accidental stop of the appliance or a power cut proceed as follows: · Keep the doors closed at all events. · Try to find out for how long the failure will continue. Once reestablished to normality: A) If the freezer is fully loaded and the power failure is less than the time indicated on the «Rating Plate» no damage has been done to the food stored. B) If the freezer is failed loaded the «rising of the temperature» is reduced. If thawing has not yet started proceed as said in previous point «A». C) If thawing has started, consume the food inmediately, or cook it and then freezen it again. 7 Maintenance of your Refrigerator-Freezer Prior to undertaking any maintenance operation, be sure to unplug the appliance. Defrosting of the freezer The inner walls of the freezer become gradually covered with a layer of frost keeping in mind not to open the door frequently and keeping the food wrapped up in closed bags. Whenever the thickness of ice reaches 5 mm. Remove all food staff and place it in the coolest possible place. 2. . . Never pull up the sticked ice, you must wait untill it is melted, when the ice is soft you can remove it by helping yourself with a plastic ice-scraper, never use sharp objects, or heating households because the appliance could be seriusly damaged. 3. . . Once removed the ice clean and dry the inside with a soft piece of cloth. [. . . ] · The «Temperature Regulator» is in position «0». · The door has been opened frecuently. · «Temperature Regulation» Inadequate pos. · Food has been introduced recently in great quantities. [. . . ]