User manual AEG-ELECTROLUX ER7326C-1

[. . . ] Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. s s Installation s s s There are working parts in this product which heat up. [. . . ] Then turn them through 45° (arrow (A) vertical) until they lock into place. Fig. 2 A 45° PR60 Door reversibility Before starting work, unplug the appliance. To reverse the opening direction of the door proceed as follows: remove the lower hinge (3), pin (1) and foot (2); unscrew the front left foot and screw it back in on the opposite side; remove the two screws which mask the holes for fixing the hinge from the front left hand side; reassemble the door; refit the lower hinge (turning it through 180°), the pin and the foot on the opposite side, as shown in the figure. Remove the handles, after having removed the screw cover and refit it on the opposite side. The holes that are not used must be masked with the plastic plugs removed. Warning: After having reversed the opening direction of the doors check that all the screws are properly tightened and that the magnetic seal adheres to the cabine". If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabine". In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. Fig. 4 1 3 2 18 0° 2 D299 Fig. 5 PR228 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. GB 12 USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. GB Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: room temperature; how often the door is opened; the quantity of food stored; location of appliance. A medium setting is generally the most suitable. To stop operation, simply turn the thermostat knob to position «O». Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. be covered and may be placed on any shelf. Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided. Butter and cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible. [. . . ] 15 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: s s Internal cleaning Never use metal objects for clearing your appliance as it may get damaged. When performing a complete defrosting, wash the internal surfaces of the freezer with lukewarm water and bicarbonate; rinse and then accurately dry. unscrew the light cover securing screws; unhook the moving part by pressing it as shown in the figure. External cleaning Wash the outer body with lukewarm water and soap. Periodically use a clearing polish to keep the outer body shining. Dust the condenser located behind the freezer with a soft brush or a vacuum cleaner. [. . . ]