User manual AEG-ELECTROLUX ER7426B

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. Ice lollies can cause frost burns if consumed straight from the appliance. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. [. . . ] Ideally, however, the appliance should not be positioned below overhanging wall units (Fig. 1-B). Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet. Important Rear spacers In the bag with the documentation, there are two spacers which must be fitted in the two top corners. Slacken the screws and insert the spacer under the screw head, then re-tighten the screws. A 10 mm 100 mm Fig. 1 B 10 mm NP002 It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent mod)fications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. D594 Fig. 2 33 Door reversibility Before carrying out the operations described below, pull out the mains plug from the wall socket. To carry out door reversal operate as follows: Remove the ventilation grill (D); Remove bottom hinge (E); Slide out the lower door from middle hinge (H) and remove the latter; Slide out the upper door from pin (5), unscrew the latter and then screw it down into the hinge provided on the opposite side; Remove the two plugs, to reveal the holes for the hinge pivots, and remount them on the other side; Refit the upper door and the middle hinge on the opposite side; Refit the lower door and bottom hinge (E) on the opposite side. Remove the plug (F) from the ventilation grill (D) and replace it on the opposite side. Refit it on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack. 5 E F F D F F After having reversed the opening direction of the doors check that all the screws are properly tightened and that the magnetic seal adheres to the cabine". If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabine". In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. Fig. 6 PR228 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATIONS The technical data is indicated in the rating plate on the left side inside the appliance. [. . . ] If the light does not go on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. The rating is shown on the light bulb cover. Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorized technicians. Internal clearing Never use metal objects for clearing your appliance as it may get damaged. When performing a complete defrosting, wash the internal surfaces of the freezer with lukewarm water and bicarbonate; rinse and then accurately dry. External clearing Wash the outer body with lukewarm water and soap. [. . . ]