User manual AEG-ELECTROLUX ER7534I

[. . . ] INFO I S T R U Z I O N I P E R L' I N S T A L L A Z I O N E E L'USO INSTALLATION AND INSTRUCTION MANUAL INSTALLATIONS- UND GEBRAUCHSANWEISUNG FRIGORIFERO-CONGELATORE FRIDGE-FREEZER KÜHL-GEFRIERSCHRANK ER 7534 I ER 7534 I ER 7534 I 2222 203-43 WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. General Safety This appliance is designed to be operated by adults. [. . . ] 1) A 1 C 2 3 B D501 D Fig. 1 Right opening Remove the pins (A) and (B) from the left side. Left opening Remove (A+B) from both sides and the door. Remove the middle hinge (2) and refit it on the opposite side. Refit the door and (A) on the left side. For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. 50-min. cm2 200 D033 19 Dimensions of housing Height of housing Depth of housing Width of housing 1446 mm 550 mm 560 mm A Fig. 3 Push appliance into housing until stop strip (A) touches the kitchen unit. D015 If after having carried out the operation just described there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance, on the stop strip (A). Fig. 4 A D265 Open the door and push the appliance against the side of the kitchen furniture opposite to that of the appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill (C) and hinge cover (D) into position. D Fig. 5 D032 C Press in the joint covers between the appliance and the kitchen unit. Fig. 6 D030 20 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 B D096 Position the runners (H) inside the kitchen unit door as shown in Fig. 8 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 8 H 20m m D094 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 8mm PR34 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). If the kitchen unit door needs to be realigned, adjust the position of the screws in the slots. [. . . ] Otherwise it is recommended that the food be used within 24 hours. Thawing Deep-frozen and frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature depending on the time available for this operation. Small pieces of food ­ such as hamburgers, chops, chips and fish fingers, for example ­ can be cooked still frozen, directly from the freezer; in this case, though, cooking will take longer. Ice cube trays The trays should be filled up to three-quarters of their height with drinking water and then placed in the freezer compartment. 25 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. [. . . ]