User manual AEG-ELECTROLUX ER8100B

[. . . ] Fridge--Freezer / Réfrigérateur--Congélateur / Kühl--Gefrierkombination / Frigorifero--Congelatore / Køle--Frysskab INSTRUCTION BOOK GEBRAUCHSANWEISUNG ISTRUZIONI D'USO NOTICE D'UTILISATION BRUKSANVISNING GB DE NL IT FR ER8100B Information on how to minimize environmental impacts is given in this manual. 818 18 57--00/7 DK Safety instructions GB Your new fridge/freezer may have other functions compared to your previous one. The edges and projecting For the User parts of the cabinet may be sharp. Be careful · The cabinet is intended for keeping foodstuff in a when moving the cabinet and always use gloves. normal household as explained in this instruction booklet. [. . . ] Then pull the grille straight out to completely remove it. Defrosting the fridge The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented by: · not putting warm foodstuff inside the cabinet. · avoiding frequently opening the door or keeping it open too long. · do not place foodstuffs directly against the cold cooling plate. 8 Electrolux 818 18 57-00/7 Cleaning Clean the cabinet at regular intervals. Don't use detergents, abrasive powders, high perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol when cleaning the product Disconnect the appliance from electricity supply. Internal Cleaning Clean the inside and accossories with warm water and bicarbonate of soda (5ml to 0, 5 litre water) Rinse and dry thoroughly. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. Clean out the drip channel inside the fridge at regular intervals and ensure that the drip channel is clear at all times. If blocked carefully clear using a piece of flexible curtain wire inserted into the drain outlet to remove the blockage. External Cleaning Wash the outer cabinet with warm soapy water. Remove the ventilation grille (see the section "Removing the ventilation grille") and vacuum-clean under the cabinet. Once or twice a year dust the condenser (black grille) and the compressor at the back of the appliance, with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. When moving the cabinet, lift it by the front edge to avoid scratching the floor. Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Remove the freezer drawers and place them on top of each other by turning every other drawer one half turn. Put insulating material around the drawers, e. g. The frozen products can also be packed closely together and be kept in a cold location, e. g. Defrosting can be accelerated by placing bowls with hot water (not boiling) inside the freezer. Take out the drain spout and place it in the bottom freezer drawer where water can collect. Loosen the ventilation grille to enable the bowl to fit under the drain spout. Carefully scrape off the ice when it starts to thaw. Do not use sharp objects as these may damage the interior. [. . . ] In this case, the space behind the cupboard must be at least 50 mm deep. Cabinet is placed at a location whose ambient temperature corresponds to the climate classification*, for which the appliance is designed. * See on the raiting plate on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classifacition. Climate classification SN N ST T for an ambient temperature of +10°C to +32°C +16°C to +32°C +18°C to +38°C +18°C to +43°C a) b) 50mm Check that the drain hose at the rear of the cabinet discharges into the drip tray. 13 Electrolux 818 18 57-00/7 If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the cabinet must be at least 10 mm to allow the door to open enough so that the shelves can be removed. 1 2 Door Reversal 1. [. . . ]