User manual AEG-ELECTROLUX ER8207C

[. . . ] They may explode and cause injury and material damage. access to the operating controls or the inside of · Do not let sharp objects come into contact with the cabinet. the refrigerating system on the back of and inside the cabinet. If the refrigerating system is Scrapping old cabinets punctured, the cabinet will be damaged and When discarding the cabinet, hand it over to a foodstuff inside may spoil. [. . . ] All parts in the packaging can be recycled. The cabinet has been designed for easy dismantling and subsequent recycling. · · · · · · · · · Maintenance and Cleaning GB Removing the ventilation grille The ventilation grille can be removed, e. g. Unsnap the ventilation grille by pulling it toward you. Cleaning Clean the cabinet at regular intervals. Don't use detergents, abrasive powers, high perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol when cleaning the product Clean out the drip channel inside the fridge at regular intervals and ensure that the drip channel is clear at all times. If blocked carefully clear using a piece of flexible curtain wire inserted into the drain outlet to remove the blockage. Eletrolux 818 17 32-00/2 11 Internal Cleaning Clean the inside and accossories with warm wather and bicarbonate of soda (5ml to 0, 5 liter water) Rinse and dry thoroughly. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. Disconnect the appliance from electricity supply. External Cleaning Wash the outer cabinet with warm soapy water. Remove the ventilation grille (see the section "Removing the ventilation grille") and vacuum-clean under the cabinet. Twice a year pull out the cabinet from the wall and vacuum-clean the back of the cabinet, the refrigerating system and the compressor. Defrosting the fridge The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented by: · not putting warm foodstuff inside the cabinet. · avoiding frequently opening the door or keeping it open too long. · do not place foodstuffs directly against the cold cooling plate. When moving the cabinet, lift it by the front edge to avoid scratching the floor. To Change the Light Bulb The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet. Fold the grille backward by unsnapping the front edge. Use a bulb of the same type, E14 socket, maximum rating of 25 W. When replacing the light bulb, use a bulb of the same type as the original one. The glass must measure at least 18 mm in diameter at the socket. This will ensure close fitting of the bulb against the rubber seal in the socket. When the appliance is not in use Disconnect the appliance from electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. Eletrolux 818 17 32-00/2 12 Something Not Working Before contacting your local Service Force Centre check the following point: GB Problem It is too warm inside the refrigerator. Possible cause / Remedy Set a lower temperature. Put food products in the right place inside the refrigerator. [. . . ] Refer to the rating plate on the left inside the cabinet. Eletrolux 818 17 32-00/2 15 Door Reversal 1. Close the cabinet and disconnect the appliance from the electricity supply. There is a part on the grille that can be removed. Put the cabinet on a wooden block when it is laid down. [. . . ]