User manual AEG-ELECTROLUX ER8209C

[. . . ] They may · Pay attention so that small children do not gain explode and cause injury and material damage. access to the operating controls or the inside of · Do not let sharp objects come into contact with the cabinet. the refrigerating system on the back of and inside the cabinet. If the refrigerating system is Scrapping old cabinets punctured, the cabinet will be damaged and When discarding the cabinet, hand it over to a recycling foodstuff inside may spoil. [. . . ] The use of an insulated container is advisable. When you arrive home place the frozen food in the freezer immediately. · Electrolux 818 17 32-03/6 12 Maintenance and Cleaning Removing the ventilation grille The ventilation grille can be removed, e. g. Unsnap the ventilation grille by pulling it toward you. GB Cleaning Clean the cabinet at regular intervals. Don't use detergents, abrasive powders, high perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol when cleaning the product Clean out the drip channel inside the fridge at regular intervals and ensure that the drip channel is clear at all times. If blocked carefully clear using a piece of flexible curtain wire inserted into the drain outlet to remove the blockage. Disconnect the appliance from electricity supply. Internal Cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0, 5 litre water) Rinse and dry thoroughly. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. External Cleaning Wash the outer cabinet with warm soapy water. Remove the ventilation grille (see the section "Removing the ventilation grille") and vacuum-clean under the cabinet. Once or twice a year dust the condenser (black grille) and the compressor at the back of the appliance, with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. When moving the cabinet, lift it by the front edge to avoid scratching the floor. To Change the Light Bulb The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet. Fold the grille backward by unsnapping the front edge. Use a bulb of the same type, E14 socket, maximum rating of 25 W. When replacing the light bulb, use a bulb of the same type as the original one. The glass must measure at least 18 mm in diameter at the socket. This will ensure close fitting of the bulb against the rubber seal in the socket. Electrolux 818 17 32-03/6 13 Defrosting the fridge The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented by: · not putting warm foodstuff inside the cabinet. · avoiding frequently opening the door or keeping it open too long. · do not place foodstuffs directly against the cold cooling plate. When the appliance is not in use Disconnect the appliance from electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. [. . . ] There is a part on the grille that can be removed. Reposition it and put it on the other side. Put the cabinet on a wooden board when it is laid down. Later, when raising the cabinet, it will be easier to grip under the cabinet thanks to the board. [. . . ]