User manual AEG-ELECTROLUX ER8301C

[. . . ] When cleaning switch off the power supply; pull out the power supply plug or deactivate the fuse. Never pull the plug out of the socket by pulling on the cable or with wet hands. Always grip the plug itself and pull it straight out of the power supply socket. High proof alcohol must only be stored well sealed and upright; further, do not store explosive materials in the appliance. [. . . ] it is the best to prepack small portions only. The electronics sense that products need to be frozen and the process control is carried out automatically. Leave the temperature control in the normal operating position, about 5 °C. Products for freezing should not be brought into contact with products which are already frozen. Products which have been thawed out must not be re-frozen because foodstuffs can spoil. Variable inner doors The cover inserts (Figure ;) in the inner doors can be adjusted somewhat and offer the option of a customized setting. To change the location of the inserts and bottle holder: first lift upwards and lift out, then set the required height and replace in the reverse sequence. Please note that the location of the cover of the uppermost cover cannot be adjusted. Ice which has formed on the back wall is melted (about once per day, see also the tips). The water flows out of the drainage channel (Figure =) and evaporates from the collection dish outside the appliance. Be sure to keep the collection channel and the drainage channel clean, so that the melted water can flow out easily. The warmer they are when put in, the longer this time will be. re-setting the temperature control has no effect on the cooling rate , only on the temperature reached. Allow warm or really hot products cool down outside the appliance. Condensation can form on the glass shelves if products are stored which emit water vapour. The electronic control defrosts the cold room only about once per day. A cat ice may be visible oftentimes at the back board of the cold room ­ this is though normal. Be careful that products do not come into contact with the rear wall of the cold room so that they do not freeze to it and that, during defrosting, water does not get diverted into the cold room. When filling be careful that: Near heaters, radiators, or smoke ventilators, and should be protected from direct sunshine. A appliance which has just been put into use needs approx. 15 hours (with products) until it has reached its normal operating temperatures. Keep the appliance doors open for as short a time as possible. [. . . ] Under no circumstances must tubing come into contact with a wall, other furniture or with another tubing. Where the appliances are installed in open-plan kitchens or in partition walls, the level of operating noise will be heard more acutely. However, this is due to the surrounding architecture and not to a fault with the appliance. The level is dependent on the size of appliance. [. . . ]