User manual AEG-ELECTROLUX ER8419B

[. . . ] If you are unsure about any of the meanings or warnings contact the Customer Care Department. The edges and projecting For the User parts of the cabinet may be sharp. Be careful · The cabinet is intended for keeping foodstuff in a when moving the cabinet and always use gloves. normal household as explained in this instruction booklet. [. . . ] Release the ice cubes by twisting the ice tray. If ice cubes are kept for a long time, they will dry out and the taste is affected. Thus, throw away old ice cubes and prepare new ones when needed. Hints and Tips GB to -20°C . Saving energy · Pay careful attention to where the cabinet is placed. See the section "Installation". When installed correctly, the cabinet will consume less energy. Try to avoid keeping the door open for long periods, or opening the door to frequently as warm air will enter the cabinet, and cause the compressor to switch on unnecessarily often. Ensure there are no obstructions prevending the door from cloosing properly. This will ensure safer defrosting of foods and reduce the work of the refridgeration unit It is advisable to periodically clean the refrigeration systemat the back of the appliance with a duster or vacuum cleaner. Always leave warm food to cool down to room temperature before placing in the fridge. Food which is to be frozen (when cool) should be placed in the fridge before being transfered to the freezer. Avoid unnecessary frosting in the cabinet by packing all foodstuffs into airtight packages before placing them in the freezer. External Cleaning Wash the outer cabinet with warm soapy water. Remove the ventilation grille (see the section "Removing the ventilation grille") and vacuum-clean under the cabinet. Once or twice a year dust the condenser (black grille) and the compressor at the back of the appliance, with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. When moving the cabinet, lift it by the front edge to avoid scratching the floor. 10 Electrolux 818 16 05-02/6 Defrosting the fridge The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented by: · not putting warm foodstuff inside the cabinet. · avoiding frequently opening the door or keeping it open too long. · do not place foodstuffs directly against the cold cooling plate. Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Remove the freezer drawers and place them on top of each other by turning every other drawer one half turn. Put insulating material around the drawers, e. g. The frozen products can also be packed closely together and be kept in a cold location, e. g. [. . . ] In this case, the space behind the cupboard must be at least 50 mm deep. Cabinet is placed at a location whose ambient temperature corresponds to the climate classification*, for which the appliance is designed. * See on the raiting plate on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classifacition. Climate classification SN N ST T for an ambient temperature of +10°C to +32°C +16°C to +32°C +18°C to +38°C +18°C to +43°C a) b) 50mm Check that the drain hose at the rear of the cabinet discharges into the drip tray. [. . . ]