User manual AEG-ELECTROLUX ER8916B

[. . . ] Ensure that you understand them all before installing or using the appliance. If you are unsure about any of the meanings or warnings contact the Customer Care Department. The edges and projecting For the User parts of the cabinet may be sharp. Be careful · The cabinet is intended for keeping foodstuff in a when moving the cabinet and always use gloves. [. . . ] Cold accumulator The cold accumulator will keep the food cold for longer after a power failure. The cold accumulator will be most effective when placed at the front of the fast-freezing tray. When freezing large amounts of food/provisions, the accumulator moves to the tray/space nearest to the lower freezing shelf. When defrosting: Place the cold accumulator on top of the frozen food to keep it cold. Release the ice cubes by twisting the ice tray. If ice cubes are kept for a long time, they will dry out and the taste is affected. Thus, throw away old ice cubes and prepare new ones when needed. Hints and Tips GB · Food which is to be frozen (when cool) should · · · · · be placed in the fridge before being transfered to the freezer. Avoid unnecessary frosting in the cabinet by packing all foodstuffs into airtight packages before placing them in the freezer. Carefully follow the advice on freezing products in the section "Using the freezer". Do not set the temperature too low in the freezer. A suitable temperature is in the range of -18°C to -20°C . Don't use detergents, abrasive powders, high perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol when cleaning the product Disconnect the appliance from electricity supply. Internal Cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0, 5 litre water) Rinse and dry thoroughly. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. Clean out the drip channel inside the fridge at regular intervals and ensure that the drip channel is clear at all times. If blocked carefully clear using a piece of flexible curtain wire inserted into the drain outlet to remove the blockage. External Cleaning Wash the outer cabinet with warm soapy water. Remove the ventilation grille (see the section "Removing the ventilation grille") and vacuum-clean under the cabinet. Once or twice a year dust the condenser (black grille) and the compressor at the back of the appliance, with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. 10 When moving the cabinet, lift it by the front edge to avoid scratching the floor. Electrolux 818 19 21-01/9 Defrosting the fridge The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented by: · not putting warm foodstuff inside the cabinet. · avoiding frequently opening the door or keeping it open too long. · do not place foodstuffs directly against the cold cooling plate. Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. [. . . ] * See on the rating plate on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification. Climate classification SN N ST T for an ambient temperature of +10°C to +32°C +16°C to +32°C +18°C to +38°C +18°C to +43°C a) b) 50mm Check that the drain hose at the rear of the cabinet discharges into the drip tray. If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the cabinet must be at least 220 mm to allow the door to open enough so that the shelves can be removed. The power plug must be accessible after installation of the cabinet. Electrical connection Connect the cabinet to a grounded electrical outlet. [. . . ]