User manual AEG-ELECTROLUX ER9007B

[. . . ] Ensure that you understand them all before installing or using the appliance. If you are unsure about any of the meanings or warnings contact the Customer Care Department. For the User · The cabinet is heavy. The edges and projecting · The cabinet is intended for keeping foodstuff in a parts of the cabinet may be sharp. [. . . ] Food that is frozen in this way will not stick together, enabling you to use only the amount required. If ice cubes are kept for a long time, they will dry out and the taste is affected. Thus, throw away old ice cubes and prepare new ones when needed. Release the ice cubes by twisting the ice tray. Freezer drawers The freezer drawers make it possible to quickly and easily find the food package you want. To gain space, the drawers can be removed and the products can be put directly on the shelves. On all shelves, except the top shelf, it is possible to place products that protrude 20 mm from the front edge. This allows maximum use of the available space. It is required to assure proper air circulation. 7 Electrolux 818 19 23-02/3 Hints and Tips Saving energy · Pay careful attention to where the cabinet is placed. See the section "Installation". When installed correctly, the cabinet will consume less energy. · do not place foodstuffs directly against the cold cooling plate. When moving the cabinet, lift it by the front edge to avoid scratching the floor. 9 Electrolux 818 19 23-02/3 Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Remove the freezer drawers and place them on top of each other by turning every other drawer one half turn. Put insulating material around the drawers, e. g. The frozen products can also be packed closely together and be kept in a cold location, e. g. Defrosting can be accelerated by placing bowls with hot water (not boiling) inside the freezer. Take out the drain spout and place it in the bottom freezer drawer where water can collect. Loosen the ventilation grille to enable the bowl to fit under the drain spout. Carefully scrape off the ice when it starts to thaw. Do not use sharp objects as these may damage the interior. When all the ice has melted, clean and wipe the cabinet dry, then push the drain spout back in place. [. . . ] The ventilation space above the cabinet must be at least 4 cm. The ventilation space can either be a) directly above the cabinet, or b) behind and above the top cupboard. In this case, the space behind the cupboard must be at least 50 mm deep. Cabinet is placed at a location whose ambient temperature corresponds to the climate classification*, for which the appliance is designed. [. . . ]