User manual AEG-ELECTROLUX ER9096BE

[. . . ] Frigorífico--Congelador / Frigorífico--Congelador / Fridge--Freezer / Réfrigérateur-Congélateur / Kombinovaná--Chladnicka / Kühl-- Gefrierkombination INSTRUCCIONES DE USO ISTRUÇÕES DE USO INSTRUCTION BOOKLET ISTRUZIONI D'USO NÁVOD NA OBSLUHU GEBRAUCHSANWEISUNG ES PO GB NL IT SK DE ER8496BA, ER9096BA, ER9096BE, ER9096BG 818 16 21-02/3 Safety instructions GB Your new fridge/freezer may have other functions compared to your previous one. Carefully read these instructions to learn how the appliance works and how to care for it. It will come in handy if you later sell the cabinet or give it to somebody else. These warnings are provided in the interests of your safety. [. . . ] Internal Cleaning Clean the inside and accossories with warm wather and bicarbonate of soda (5ml to 0, 5 liter water) Rise and dry thoroughly. Regularly check the door seals and wipe clean to ensur they are clean and free from debris. Clean out the drip channel inside the fridge at regular intervals and ensure that the drip channel is clear att all times. If bocked carefully clear using a piece of flexible curtain wire inserted into the drain outlet to remove the blockage. External Cleaning Wash the outer cabinet with warm sopy water. Remove the ventilation grille (see the section "Removing the ventilation grille") and vacuum-clean under the cabinet. Twice a year pull out the cabinet from the wall and vacuum-clean the backside of the cabinet, the refrigerating system and the compressor. When moving the cabinet, lift it by the front edge to avoid scratching the floor. 37 Electrolux 818 16 21--02/3 Defrosting the fridge The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented by: · not putting warm foodstuff inside the cabinet. · avoiding frequently opening the door or keeping it open too long. · do not place foodstuffs directly against the cold cooling plate. Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Remove the freezer drawers and place them on top of each other by turning every other drawer one half turn. Put insulating material around the drawers, e. g. The frozen products can also be packed closely together and be kept in a cold location, e. g. Defrosting can be accelerated by placing bowls with hot water (not boiling) inside the freezer. Take out the drain spout and place it in the bottom freezer drawer where water can collect. Loosen the ventilation grille to enable the bowl to fit under the drain spout. Carefully scrape off the ice when it starts to thaw. Do not use sharp objects as these may damage the interior. When all the ice has melted, clean and wipe the cabinet dry, then push the drain spout back in place. Switch on the cabinet and replace the frozen foodstuff. To Change the Light Bulb The light is switched on automatically when the door is opened. [. . . ] Close the cabinet and pull out the plug from the electrical outlet. There is a part on the grille that can be removed. Put the cabinet on a wooden board when it is laid down. Later, when raising the cabinet, it will be easier to grip under the cabinet thanks to the board. [. . . ]