User manual AEG-ELECTROLUX ER9099BCRE

[. . . ] F r i d g e -- f r e e z e r / J ä ä -- p a k a s t i n k a a p p i / K y l -- f r y s s k å p NL INSTRUCTION BOOK KÄYTTÖOHJE BRUKSANVISNING ER9098BSAN, ER9099BCRE GB FI 818 19 23--02/3 SE Safety instructions GB Your new fridge/freezer may have other functions compared to your previous one. Carefully read these instructions to learn how the appliance works and how to care for it. It will come in handy if you later sell the cabinet or give it to somebody else. These warnings are provided in the interests of your safety. [. . . ] Follow the advice in the section "Saving energy" The door gasket and coolant used in this cabinet will not harm the ozone layer. All parts in the packaging can be recycled. The cabinet has been designed for easy dismantling and subsequent recycling. · · · · · · Maintenance and Cleaning GB Please observe that the care advice in this chapter is general. Some interior parts cannot for example be washed, advice on cleaning these fixtures is given in section "optional -equipment". Therefore, please read the instructions manual through carefully before use. Removing the ventilation grille The ventilation grille can be removed, e. g. Unsnap the ventilation grille by pulling it toward you. 8 Electrolux 818 19 23-02/3 To change the light bulb The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet. Fold the grille backward by unsnapping the front edge. Use a bulb of the same type, E14 socket, maximum rating of 25 W. When replacing the light bulb, use a bulb of the same type as the original one. The glass must measure at least 18 mm in diameter at the socket. This will ensure close fitting of the bulb against the rubber seal in the socket. Cleaning Clean the cabinet at regular intervals. Don't use detergents, abrasive powders, high perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol when cleaning the product Disconnect the appliance from electricity supply. Internal Cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0, 5 litre water) Rinse and dry thoroughly. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. Clean out the drip channel inside the fridge at regular intervals and ensure that the drip channel is clear at all times. If blocked carefully clear using a piece of flexible curtain wire inserted into the drain outlet to remove the blockage. External Cleaning Wash the outer cabinet with warm soapy water. Remove the ventilation grille (see the section "Removing the ventilation grille") and vacuum-clean under the cabinet. Once or twice a year dust the condenser (black grille) and the compressor at the back of the appliance, with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. Defrosting the fridge The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented by: · not putting warm foodstuff inside the cabinet. · avoiding frequently opening the door or keeping it open too long. [. . . ] * See on the rating plate on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification. Climate classification SN N ST T for an ambient temperature of +10°C to +32°C +16°C to +32°C +18°C to +38°C +18°C to +43°C a) b) 50mm If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the cabinet must be at least 10 mm to allow the door to open enough so that the shelves can be removed. Check that the drain hose at the rear of the cabinet discharges into the drip tray. The power plug must be accessible after installation of the cabinet. Electrolux 818 19 23-02/3 13 Door Reversal 1. [. . . ]