User manual AEG-ELECTROLUX ERB4024

[. . . ] Ensure that you understand them all before installing or using the appliance. If you are unsure about any of the meanings or warnings contact the Customer Care Department. For the User · · · The cabinet is intended for keeping foodstuff in a normal household as explained in this instruction booklet. Do not keep explosive gases or liquids in the refrigerator or freezer compartment. They may explode and cause injury and material damage. [. . . ] See the section "Installation". When installed correctly, the cabinet will consume less energy. Try to avoid keeping the door open for long periods, or opening the door too frequently as warm air will enter the cabinet, and cause the compressor to switch on unnecessarily often. Ensure there are no obstructions preventing the door from closing properly. This will ensure safer defrosting of foods and reduce the work of the refrigeration unit It is advisable to periodically clean the refrigeration system at the back of the appliance with a duster or vacuum cleaner. Always leave warm food to cool down to room temperature before placing in the fridge. Food which is to be frozen (when cool) should be placed in the fridge before being transfered to the freezer. Avoid unnecessary frosting in the cabinet by packing all foodstuffs into airtight packages before placing them in the freezer. Carefully follow the advice on freezing products in the section "Using the freezer". Do not set the temperature too low in the freezer. A suitable temperature is in the range of -18°C to -20°C . Wash the outer cabinet with warm soapy water. Remove the ventilation grille (see the section "Removing the ventilation grille") and vacuum-clean under the cabinet. Once or twice a year dust the condenser (black grille) and the compressor at the back of the appliance, with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. When moving the cabinet, lift it by the front edge to avoid scratching the floor. Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Remove the freezer drawers and place them on top of each other by turning every other drawer one half turn. Put insulating material around the drawers, e. g. The frozen products can also be packed closely together and be kept in a cold location, e. g. Defrosting can be accelerated by placing bowls with hot water (not boiling) inside the freezer. Loosen the drainage channel from its resting position and push in according to the illustration and place it in the bottom freezer drawer where water can collect. Carefully scrape off the ice when it starts to thaw. [. . . ] · there is good air circulation around the cabinet and that the air channels below and behind the cabinet are not blocked. The ventilation space above the cabinet must be at least 4 cm. The ventilation space can either be a) directly above the cabinet, or b) behind and above the top cupboard. In this case, the space behind the cupboard must be at least 50 mm deep. [. . . ]