User manual AEG-ELECTROLUX ERD 7848

[. . . ] These instructions must be followed under all circumstances. These numbers take you step by step through the operating sequence for this appliance. After this symbol you will find additional information relating to the operation and practical application of the appliance. This symbol denotes tips and hints relating to the economical and ecofriendly use of the appliance. [. . . ] Then allow the filter to cool down completely for two hours. If the filter is inserted to soon the extractor hood may be damaged as a result of the residual heat of the carbon. The regeneration process may result in a normal discoloration of the filter. The filter can then be placed in the extractor hood again. Your appliance is now ready for use. 8 electrolux Extractor hood controls Always switch the extractor hood on before starting cooking. Switching the appliance on / off · Pull out the extending hood. · Press the button for the required speed. When a speed button is pressed the fan is switched on and the associated LED lights up. The fan speed is switched off by pressing the button again. Grease filter monitor function The monitor function for the grease filter is enabled by default. After 40 hours of operation, indicator light f is continuously illuminated when the hood is extended. 5 electrolux 13 Regeneration Moisture and grease particles reduce the absorbent capacity of the activated carbon, so it must be regenerated after 2 months at the latest. Lay the filter cassette flat on the oven shelf in the middle of your oven and heat it up for an hour at 230 °C. Then allow the filter to cool down completely for two hours. The filter can then be placed in the extractor hood again. Your appliance is now ready for another 2 months use. The filter loses its effectiveness after approx. 4 years, and should then be completely replaced (it is not possible to refill the activated carbon). Inserting the activated carbon filter 5. Push the activated carbon filter into the brackets in the direction of the arrow, than fold up at the front until the springs click in place. Insert metal filters. 5 14 electrolux Replacing the halogen bulbs The extractor hood must be disconnected from the mains supply. (Pull out the plug or switch off the circuit breaker. ) Caution! [. . . ] The extracted air has to be drawn off through a separate pipe to the open air. If this principle is not observed, a drastic loss of performance and increased operating noise are to be expected. 150 max. 140 4/6= 508 5/6= 635 1629 1502 Removable rear panel 49 17 ( Griff ) 319 200 6/6= 762 5/6= 635 150 100 495 550 600 548 598 A 319 N 330 2050 138 325 0-50 electrolux 17 Installation with herbs and spices cupboard, height 635 mm (5/6), new, and installation with herbs and spices cupboard, height 508 mm (4/6) with door 635 mm (5/6), replacement market. Use the templates and follow the instructions on them. max. If no back draught flap is installed it is absolutely necessary to have an air vent of at least 200 cm2! [. . . ]