User manual AEG-ELECTROLUX ERF3110AOW

[. . . ] You’ve chosen a product that brings with it decades of professional experience and innovation. ingenious and stylish , it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time. Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. [. . . ] 4 Bottle rack Place the bottles (with the opening facing front) in the pre-positioned shelf. If the shelf is positioned horizontally, place only closed bottles. This bottle holder shelf can be tilted in order to store previously opened bottles. To obtain this result, pull the shelf up so it can rotate upwards and be placed on the next higher level. 5 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Do not move the big lower door shelf to ensure correct air circulation. 6 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Check that the drain hose at the rear of the cabinet discharges into the drip tray 4. 1 Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary. Do not place food against or close to the temperature sensor (A) or any shelves towards the water drain hole. This can result in too cold temperatures. €¢ If you want to check the temperature of food stored in the refrigerator, place a glass of water centrally in the cabinet, and put a proper thermometer with an accuracy of +/– 1 °C into it. After 6 hours the temperature can be monitored. The measuring shall be performed under steady-stated conditions (without changing the load). Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Clean the condenser (black grill) and the compressor at the back of the appliance with a brush. This operation will improve the performance of the appliance and save energy consumption. Take care of not to damage the cooling system. When moving the cabinet, lift it by the front edge to avoid scratching the floor. [. . . ] €¢ Remove the cover (4) on the opposite side and install the support (3) the cover plate (2) and the hinge (1). Install the cover (4) on the opposite side. • Unscrew the lower hinge (1). €¢ Unscrew and move the pedal to the opposite side (3). [. . . ]