User manual AEG-ELECTROLUX ERL7280W

[. . . ] 2 Important Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 5 Door Removal Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Features at a Glance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To condition filter system and purge air from water line, fill a glass with water. Continue flushing the system for approximately 3 minutes to assure that the purest water possible is stored in the water tank. Order new filter cartridges through the dealer where you bought the refrigerator or contact the Electrolux Customer Care Center . It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the RG100 PureSourceTM replacement cartridge. The PureSourceTM NGRG2000 Ice and Water Filter System with the RG-100 cartridge is tested and certified by NSF International, the nationally recognized and respected, not for profit, certification organization for public health safety. The PureSourceTM system is tested and certified to ANSI/NSF Standard 42. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system. · Rated Capacity - 1514 liters · Rated service flow - 1. 9 liters per minute · Maximum Rated Pressure - 6. 9 bars · Maximum Operating Temp. - 37. 8° C IMPORTANT: Resetting The Filter Status Light (some models) After replacing the filter cartridge, it will be necessary to press the Filter Status reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10-15 seconds). · Rated Capacity - 1514 liters · Rated service flow - 1. 9 liters per minute · Maximum Rated Pressure - 6. 9 bars · Maximum Operating Temp. Pull the old filter cartridge straight out of the housing. Remove the new filter cartridge from the packaging and insert into the filter housing the same way the old one came out. When the cartridge is almost in, you will feel it stop against the clip assembly in the back of the housing. The clip assembly holds the filter cartridge firmly in place. At this point, you will need to push firmly until the cartridge snaps fully in place. When completely in place, the front of the filter cartridge will be flush with the front of the housing. Turn the ice maker's power switch to the On ("I") position. As you are doing this, check for leaks at the filter housing. There will be noticeable spurts and sputters as the system pushes the air out through the system and out the dispenser nozzle. After you have run one glass of water, continue to flush the system for approximately 3 minutes to assure that the purest water possible is stored in the water storage tank. IMPORTANT: Resetting The Filter Status Light (some models) After replacing the filter cartridge, it will be necessary to press the Filter Reset button located on the ice and water dispenser. [. . . ] Draw and discard 10 ­ 12 glasses of water to freshen the supply and completely rinse out the tank. Connect unit to cold water line that supplies water to the kitchen faucet. For best results, use copper tubing for water connections. CAUSE CORRECTION · Water pressure is extremely low. · · · · · Contact water treatment plant for help. [. . . ]