User manual AEG-ELECTROLUX ERN2301AOW

[. . . ] In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. For the safety of life and property keep the precautions of these user's instructions as the manufacturer is not responsible for damages caused by omission. [. . . ] ⷠThis product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Before maintenance, switch off the appliance and disconnect the mains plug from the mains socket. ⷠDo not clean the appliance with metal objects. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symare recyclable. For electrical connection carefully follow the instructions given in specific paragraphs. Report possible damages immediately to the place Insert the plug into the wall socket. To turn off the appliance, turn the Temperature regulator to the "O" position. Turn the Temperature regulator toward lower settings to obtain the minimum coldness. ⷠTurn the Temperature regulator toward higher settings to obtain the maximum coldness. a medium setting is generally the most suitable. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: · room temperature · How often the door is opened · In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. The glass shelf incorporates a device with slits (adjustable by means of a sliding lever), which makes it possible to regulate the temperature in the vegetable drawer(s). When the ventilation slots are closed: the natural moisture content of the food in the fruit and vegetable compartments is preserved for longer. [. . . ] The melting water outlet Attach the melting water does not flow in the evapo- outlet to the evaporative rative tray above the com- tray. Decrease to room temperature before storage. Many products are stored at the same time. There is no cold air circulation in the appliance. [. . . ]