User manual AEG-ELECTROLUX ERN2320

[. . . ] The appliance must not be located close to radiators or gas cookers. Avoid prolonged exposure of the appliance to direct sunlight. There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. For freezers only (except built-in models): an ideal location is the cellar or basement. [. . . ] It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. If the appliance has been transported horizontally, it is possible that the oil contained in the compressor ílows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow tlie oil to flow back in the compressor. s This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. The materials used on this appliance marked with the symbol are recyclable. s s s CONTENTS Installation s s s GB 41 42 42 42 42 42 36 36 36 37 39 39 40 40 40 40 41 s Defrosting Positioning Cleaning the interior Instructions for totally built-in appliances Electrical connection Maintenance s s s Periodic cleaning Extended periods of non-operation Interior light s Technical specification Use s s s s s Defective operation Operation Temperature regulation Fresh food refrigeration Movable shelves Positioning the door shelves 35 INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 7 A 20m m PR33 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 8 8mm PR34 Remove the little plates and make the holes with a diam. Replace the little platee over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 9 38 PR35 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATIONS The technical data is indicated in the rating plate on the left side inside the appliance. GB 39 USE Operation Insert the plug into the wall socket. [. . . ] In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Fresh food refrigeration To obtain the best performance: do not store warm food or evaporating liquide in the refrigerator do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circuiate freely round it. Useful hints: Meat (all types): wrap in polythene bags and place on the glass shelf above the vegetable 40 Fig. 11 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. [. . . ]