User manual AEG-ELECTROLUX ERO2170

[. . . ] For freezers only (except built-in models): an ideal location is the cellar or basement. Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances. · · Service Centre, and always insist on genuine spare parts. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. · · · · · Use · The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. [. . . ] For safety reasons, minimum ventilation must be as shown in the instructions. Attention: keep ventilation openings clear of obstruction. · Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. · If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Difference between the temperature displayed and temperature setting is normal. Especially when: - a new setting has recently been selected - the door has been left open for a long time - warm food has been placed in the compartment 4 9 Customer service and spare parts If the appliance is not functioning properly, check that: · · · · the plug is firmly in the wall socket and the mains power switch is on; there is an electricity supply (find out by plugging in another appliance); the thermostat knob is in the correct position. If there are water drops on the bottom of the cabinet, check that the defrost water drain · opening is not obstructed (see "Defrosting" section). If your appliance is still not working properly after making the above checks, contact the nearest service centre. F. Auto Fresh pilot light G. Auto Fresh button The maximum performance is obtained by setting the Auto fresh function. It's recommended when loading large quantities of food. Press the Auto fresh button (G). The relevant pilot light (F) switches on. The internal temperature goes down to +2°C. After about 6 hours the supercooling function switches off automatically. Fresh food refrigeration To obtain the best performance: · · · do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it. To obtain fast service, it is essential that when you apply for it you specify the model and serial number of your appliance which can be found on the guarantee certificate or on the rating plate located inside the appliance, on the bottom left-hand side. H. light Installation Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. [. . . ] The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with the following E. E. C. Directives: - 87/308 EEC of 2/6/87 relative to radio interference suppression. - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. D338 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. [. . . ]