User manual AEG-ELECTROLUX ESE5608TA

[. . . ] 2. 5 Push the TEMP button ( or ) to set the time you want to stop the operation. 2. 6 After setting the TIMER there will be a one-half second delay before the remote controller transmits the signals to the Air Conditioner. Then after approximately another 2 seconds, the set temperature will re-appear on the digital display. Set the STARTING & STOPPING time 3. 1 Please press the CANCEL button to cancel any former settings. [. . . ] Then, after approximately another 2 seconds , the set temperature will re-appear on the digital display. ! ~ Performance Features 1. Indoor Setting Temperature Range : 17 C~30 C. LCD (Liquid Crystal Display) of all functions. HEAT(For Heat pump models only)) Features of the Remote Controller AUTO COOL DRY HEAT FAN HIGH MED LOW TEMP 1 MODE ON/OFF FAN 7 2 SWING ECONOMY TIMER 8 9 10 RESET LOCK 3 4 5 6 DIGITAL DISPLAY CANCEL NOTE R 11 12 1. Please reset the TIMER after cancelling the former time settings. That is the time set is based on the delay of the current time. Fig. 1 1 6 COOL , HEAT and FAN ONLY Operation , 1. If the AUTO mode is not comfortable , you may manually override the settings by using COOL, DRY, HEAT( HEAT PUMP models only), or FAN ONLY modes. Push the TEMP button to set the desired room temperature. When in COOLING mode, the most comfortable settings are 21 C or above. When in HEATING mode, the most comfortable settings are 28 C or below. 1. 4 After setting the TIMER there will be a one-half second delay before the remote controller transmits the signal to the Air Conditioner. Then, after approximately another 2 seconds , the set temperature will re-appear on the digital display. 10 11 12 5 2 Names and Functions of indicators on Remote Controller Display Panel 1 2 6 5 Operating the Remote Controller Install / Replace Batteries The Remote Controller uses two alkaline dry batteries(R03/Ir03X2). To install batteries, slide back the cover of the battery compartment and install the batteries according to the directions (+and -) shown on the Remote Controller. To replace the old batteries , use the same method as mentioned above. AUTO COOL DRY HEAT 3 4 FAN HIGH MED LOW NOTE 1. When replacing batteries, do not use old batteries or a different type battery. This may cause the remote controller to malfunction. If you do not use the remote controller for several weeks remove the batteries. Otherwise battery leakage may damage the remote controller. The average battery life under normal use is about 6 months. Replace the batteries when there is no answering beep from the indoor unit or if the Transmission Indicator light fails to appear. 1 Fig. 2 TRANSMISSION Indicator: This indicator lights when remote controller transmits signals to indoor unit. [. . . ] If only the turning off time of operation is set, it will display the TIMER OFF. If both operations are set, it will show TIMER ON- OFF which indicates you have chosen to set both the starting time and off time. FAN Display: When the FAN button is pushed, this signal indicator lights. Digital Display Area: This area will show the temperature and, if in the TIMER mode, will show the ON and OFF settings of the TIMER. ! 2 3 AUTOMATIC OPERATION When the Air Conditioner is ready for use, switch on the power and the OPERATION indicator lamp on the display panel of the indoor unit starts flashing. [. . . ]