User manual AEG-ELECTROLUX ESER07PCGMA

[. . . ] 2. 3 Push the TEMP button to cancel the TIMER ON setting. The digital area will show "00". 2. 4 Push the TIMER button and the remote controller will show the last set time for the STOP operation and the signal "h" will be shown on the display panel. You are now ready to reset the time of the STOP operation. [. . . ] button again to stop this unit operation. 1 TEMP Button : Push the TEMP button to decrease the indoor temperature setting or to adjust the TIMER in a counter-clockwise direction. MODE Select Button: Each time you push the button, a mode is selected in a sequence that goes from AUTO COOL DRY HEAT and FAN as the following figure indicates: AUTO ! 2 COOL DRY HEAT FAN NOTE: HEAT feature only for Heat Pump models. 3 SWING Button: Push this switch button to change the louver angle . Push this button to go into the Energy-Saving NOTE The FAN ONLY mode cannot be used to control the temperature. While in this mode, only steps 1 3 and 4 may be performed. 4 DRY OPERATION 1. Push the TEMP button to set the desired temperature from 21 C to 28 C. The operation lamp lights and the air conditioner starts to operate in the DRY mode. Push the ON/OFF button again to stop this unit operation. ! 5 RESET Button: When the RESET button is pushed, all of the current settings are cancelled and the control will return to the initial settings. DIGITAL DISPLAY Button: Press this button to clear the digit display in the air conditioner, press it again to activate it. TEMP Button : Push the button to increase the indoor temperature setting or to adjust the TIMER in a clockwise direction. FAN Button: This button is used for setting Fan Speed in the sequence that goes from AUTO LOW MED to HIGH, then back to Auto. ON/OFF Button: Push this button to start the unit operation. Push the button again to stop the unit operation. TIMER Button: This button is used to preset the time ON (start to operate) and the time OFF (turn off the operation). CANCEL Button: Push this button to cancel the TIMER settings. LOCK Button: Push this button to lock in all the current settings. To release settings, push again. ! 6 7 NOTE 8 Due to the difference of the set temperature of the unit and the actual indoor temperature, the Air Conditioner when in DRY mode will automatically operate many times without running the COOL and FAN mode. 9 TIMER OPERATION PUSH TIMER button to set the on and off times of the unit. 1. 1 Please push the CANCEL button to cancel any former settings. The remote controller will show the TIMER and the signal "h" is shown on the display panel. [. . . ] Use the MODE select button to select AUTO. Push the TEMP button to set the desired room temperature. The most comfortable temperature settings are between 21 C to 28 C. Push the ON/OFF button to start the air conditioner. [. . . ]