User manual AEG-ELECTROLUX ESF 2435

[. . . ] Contents For the user Safety information Description of the appliance - Spray arm - Coarse strainer/microfilter - Fine filter - Detergent dispenser - Rinse aid dispenser - Water softener - Cleaning the dishwasher For the installer 3 4-5 Technical specifications Unpacking - Damages - Use - Positioning - Protecting the dishwasher against freezing 13 14 Installation 6 7 8 9 - Water inlet - Water drainage - Electrical connection 15 The control panel - How to set the delayed start Gebrauchsanweisung 16 Adjusting the water softener Programme chart Using the appliance - Starting the programme - Stopping the programme temporarily - Cancelling the programme - Pause function - Cancelling the drying phase - Switching the dishwasher off Loading and unloading In the event of a fault Service - Service and spare parts 10 11 12 12 Information for test centres Guide to use the instruction book The following symbols will be found in the text to guide you throughout the instructions: Safety information Step by step instructions Hints and tips Environmental information -2- Safety information Before installing and first using the dishwasher, read this instruction booklet carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the dishwasher are thoroughly familiar with its operation and safety features. Save these instructions and make sure they remain with the dishwasher if it is moved or sold, so that everyone using it through its life can be properly informed on appliance use and safety. Installation and servicing q q Do not place sharp knives with their points upwards. It is much safer to lay them horizontally in the basket. [. . . ] During the three seconds the two top indicator lamps are flashing, you can select another programme cycle. The lamp allways indicates which part of the selected cycle the dishwasher is in. Check the strainers/filters to see if they need to be cleaned when the dishwasher has finished the programme. If both the top and middle indicator lights are flashing, first check that the door is properly closed, otherwise read the section "In the event of a fault". Pause function With the paus function the programme can be temporarily disrupted for a short period of time. When you want the programme to continue again, you press the On/Off button. The programme should not be paused for any longer than necessary, because the water inside the dishwasher has cooled down and must be heated again which increases the power consumption. Cancelling the drying phase In case you do not want to wait until the drying phase is completed, you can cancel it. The control lamp for the On/Off button goes out. The drying phase is cancelled. Switching the dishwasher off Switch the dishwasher off, when the indicator lamp for the programme cycle end is lit. The control lamp for the On/Off button goes out. Be careful if you open the door immediately after the programme is finished, since hot steam may escape. This dishwasher has a new feature called "IMPULSE WASHING". This washing system varies both the revolutions of the pump and the water pressure for more intensive cleaning of the dishes during a programme. That is why different sections of the programme cycle do not sounds the same. Stopping the programme temporarily 1. Close the door and the programme continues after about six seconds. Open the door carefully when the dishwasher is running, since hot steam may escape. Cancelling the programme 1. Press and hold in the combination buttons until the indicator light for the programme goes out. The programme is now cancelled and a new programme can be selected. If you switch the dishwasher off, the selected programme is not finished, it is only disrupted. When you start the dishwasher again, the programme will continue. -9- Loadind and unloading the dishwasher How to load the dishes The illustration shows the dishwasher loaded with six place settings. Your own dishes are not likely to be identical to this load, but if you follow the advice below we are sure you will be pleased with the results. q q Baskets Main basket Cutlery basket The cup shelves can be placed in two different levels. Always place glasses, cups and bowls upside down. Incline deep dishes (soup plates etc. ) so that the water can run off when drying. Make sure that the dishes do not rest against each other. [. . . ] The manufacture is not responsible for any frost damage. - 14 - Installation Water inlet The dishwasher is equipped with safety features which are to prevent the water from going back to the fresh water system. These features are according to current water technical safety regulations. The temperature of the water supply should not exceed 65° C and the pressure should be between 80-1000 kPa (0, 8 - 10 bar). It is important to have a tap or stopcock, positioned close to the dishwasher and with easy access. [. . . ]