User manual AEG-ELECTROLUX ESF4130

[. . . ] Dishwasher Model ESF 4130 GB Instruction book Contents For the user Important safety information Description of the appliance The control panel Before use Setting the water softener Rinse aid Using your appliance Loading your appliance Adjusting the height of the upper basket Use of detergent Hints and tips Washing programmes Operating sequence Maintenance and cleaning Something not working Protection against flooding Security system Technical specifications 3 4 5 6 6 9 10 10 11 12 13 14 15 17 19 20 20 20 For the installer Installation instructions Water supply connections Water outlet hose connection Electrical connection Fitting under a counter Levelling Hints for test centres 21 21 22 22 23 23 23 Guide to use the instruction book The following symbols will be found in the text to guide you throughout the instructions: Safety instructions 1. Step by step Hints and tips Environmental information 2 Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety. [. . . ] Characterised by a duration of about 80 minutes and a washing temperature of 70°C. The time value is approximated and depends on the pressure and the temperature of the water and also by the variations of the power supply. This is the daily programme for excellence. ** Ideal for washing crockery and cutlery of breakfast and dinner (fresh soil). Characterised by a duration of about 30 minutes and a washing temperature of 65°C. The time value is approximated and depends on the pressure and the temperature of the water and also by the variations of the power supply. This is the perfect daily programme, made to meet the needs of a family of 4 persons who load crockery and cutlery of breakfast and dinner. *** Testing programme for EN 50242 (see "Hints for Test Centres). 14 Operating sequence 1. Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning"). 8a. Setting and starting the programme without DELAY START Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates and the phase indicator lights foreseen for that programme start flashing. Select, if required, the HALF LOAD option. 2. Press the ON-OFF push button The ON-OFF indicator light will come on. 3. Check that there is rinse aid and salt The corresponding indicator lights will illuminate if refilling is necessary. The start of the programme will occur after about 6 seconds from the last pressure of a push button (programme or HALF LOAD push button), in this time it is possible to change programme simply pressing the push button of another programme. Once the programme has started the phase indicator lights will turn off except for the phase under way. It is possible to interrupt the programme: q q 4. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. opening the door pressing the ON-OFF (in this case all the indicator lights turn off) Close the door again o press the ON-OFF, the programme will start from the point in which it was interrupted. 5. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the recommended quantity given in the Washing programmes chart. If the half load option is selected remember to reduce the quantity of detergent. Close the detergent dispenser lid. 8b. Setting and starting the programme with DELAY START The setting of the delay start occurs before selecting the programme. [. . . ] Hooked over the edge of the sink using the special curved plastic guide provided. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. CS09 Ø 18 max 100 cm The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. Ø 18 Ø 21 The drain hose can face either to the right or left of the dishwasher Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. [. . . ]