User manual AEG-ELECTROLUX ESF489

[. . . ] You MUST read it carefully before installing or using the appliance. Installation s s s s s s This appliance is heavy. It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ] Insufficient quantities of detergent will produce poor washing results, whereas an excessive amounts of detergent will not improve washing results and is also wasteful. Using no more than the correct amount also contributes to reducing pollution. DE07 D DE02 Phosphate free detergents with enzymes In these low-alkaline compact powders the environment unfriendly components have been replaced by natural enzymes and other more biodegradable substances. These new compact powders are generally phosphate-free. As phosphates have water softening properties, we suggest you add salt to the salt container even if the hardness of your water is as low as 4°dH (7°TH). This will avoid lime deposits on crockery and the inner tub. 9 M M IN AX PUD01GB Using your appliance Loading your appliance Before placing dishes in the machine, remove any scraps of food, to avoid clogging the filters and consequently reducing the performance. Do not load very small items which can fall through the baskets. Open the door and slide out the baskets to load the dishes. The lower basket The lower basket is designed to take saucepans, lids, plates (up to 27 cm in diameter), salad bowls, cutlery etc. Serving dishes and large lids should be arranged around the edge of the basket, ensuring that the upper spray arm can turn freely. UI31 IEC 436 / DIN 44990 The cutlery basket Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carvings knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. Cutlery should be placed in the removable cutlery basket with the handles facing downwards. 42 minutes) a full load of lightly soiled dishes, 13 PWP31GB Operating sequence 1. Check the filters Ensure they are clean and properly positioned (see cleaning instructions). 8. At the end of the washing programme At the end of the washing programme the machine stops automatically. The On/Off indicator light remains on until the On/Off button is depressed. 2. Check that there is rinse aid and salt Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the basket back into the machine. 3. 9. Switch off the dishwasher Switch off the dishwasher by pressing the On/Off button and open the door. When the wash programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working;if the door is opened however, a safety device ensures that the machine stops. Caution Do not open the door during the hot phase: this may cause hot water escape. Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. 4. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the "Washing programmes" chart and close the lid. 5. 6. Set the programme The selection of a programme occurs with the door partially opened. Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker. [. . . ] The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation. The locknut must be correctly fitted to avoid water leaks. Avoid bends or kinks in the hose which could prevent or slow down the water supply. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. [. . . ]