User manual AEG-ELECTROLUX ESF63029

[. . . ] If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. Any electrical and plumbing work required to install this appliance should be carried out by a qualified and competent person. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. [. . . ] This programme does not require the use of detergent. 120 - 130 1. 7 - 1. 9 23 - 25 Normal 65° Normal soil. Crockery and cutlery 65° 108 - 118 1. 7 - 1. 8 24 - 26 Quick 30I 60° Light soil. Crockery and cutlery 60° 25 - 35 0. 7 - 0. 8 8 (1) Normal-Eco 50° Normal soil. Crockery and cutlery 50° 100 0, 6 16 - 17 Rinse Any. Partial load (to be completed later in the day). 12 < 0. 1 4 (1) Testing programme for AS 2007. This programme is recommended to wash a normally soiled load of 12 place settings. (2) The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply. Note: Anti-Bac function gives a greater degree of hygiene to dishes and glasses. In the last rinse the temperature will be held at over 65°C for at least 10/11 minutes. 11 Starting a Washing Programme 1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 2. Setting and starting the programme Turn the programme selector dial until the marker on the dial corresponds with the desired programme (see "Washing programmes" chart). The dishes should therefore be allowed to cool down before removing from the appliance. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. To cancel a delay start in progress Press the start/cancel button for about 5 seconds, the indicator lights of start/cancel and delay start buttons turn off while the indicator lights of the phases start flashing. To start the selected washing programme press the start/cancel button. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. NOTE: the washing programme or the countdown of the delay start will begin only after having pressed the start/cancel button. Until that moment it is possible to modify the selection made. 12 Maintenance and Cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash programme without dishes using detergent. Attention! Under no circumstances may the dishwasher be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. NEVER try to remove the upper spray arm. If soil residue has clogged the holes in the upper spray arm, remove them with a cocktail stick / toothpick. Cleaning the filters The filters must be checked and cleaned from time to time. [. . . ] Electrolux is not liable in the following situations (which are not exhaustive): (a) The Appliance is damaged by: (i) accident (ii) misuse or abuse, including failure to properly maintain or service (iii) normal wear and tear (iv) power surges, electrical storm damage or incorrect power supply (v) incomplete or improper installation (vi) incorrect, improper or inappropriate operation (vii) insect or vermin infestation. (b) The Appliance is modified without authority from Electrolux in writing. (c) The Appliance's serial number or warranty seal has been removed or defaced. (d) The Appliance was serviced or repaired by anyone other than Electrolux or its Authorised Service Centres. [. . . ]