User manual AEG-ELECTROLUX ESF6546S

[. . . ] We promise that it will provide a superior User Experience delivering Ease-of-Mind. Good luck! 4 electrolux contents Contents Safety information Product description Control panel First use Daily use Washing programmes Care and cleaning Something not working Technical data Hints for test institutes Installation Environment concerns Guarantee/Customer Service 5 7 8 11 15 28 30 32 35 37 38 43 44 The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information safety information electrolux 5 Safety information q In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. [. . . ] Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Cancelling a delay start involves also the cancelling of the washing programme set. In this case you have to set the washing programme again. Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary. Hot steam may escape when the door is opened. Interrupt a washing programme in progress: q Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. q Press the On/Off button, all lights will turn off. Press the On/Off button again; the programme will start from the point at which it was interrupted. daily use electrolux 27 Unloading the dishwasher q Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance. q Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. q Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. 28 electrolux washing programmes Washing programmes Programme Degree of soil Type of load Programme description Prewash Main wash up to 70C 2 intermediate rinses Final rinse Drying Prewash Main wash up to 50C or 65C 2 intermediate rinses Final rinse Drying Main wash up to 60C Final rinse Prewash Main wash up to 50C 1 intermediate rinse Final rinse Drying Main wash up to 45C 1 intermediate rinse Final rinse Drying Heavy soil Intensive Crockery, cutlery, pots and pans Normal soil Auto Crockery, cutlery, pots and pans Light soil Quick Crockery and cutlery Normal soil Eco Crockery and cutlery Normal soil Glass Delicate crockery and glassware washing programmes electrolux 29 Washing programmes information "Auto" washing programme During the "Auto" washing programme the amount of soil on the dishes is determined by how cloudy the water is. If the appliance is partially loaded and the dishes lightly soiled, the "prewash", "main wash", and "rinse" phases of the programme are shorter and the water consumption level is lower. If the appliance is fully loaded and the dishes heavily soiled, the "prewash", "main wash", and "rinse" phases of the programme are longer and the water consumption level is higher. Pull the machine out together with the hoses. Avoid over tilting the machine during transportation. External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65C wash programme without dishes using detergent. 32 electrolux care and cleaning Something not working The dishwasher will not start or stops during operation. Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer. Switch off the dishwasher, open the door and carry out the following suggested corrective actions. Fault code q Malfunction q Possible cause The water tap is blocked or furred with limescale q Solution Clean the water tap continuous flashing The dishwasher of the light of the does not fill with running water programme appears in the digital display q The water tap is turned off q The filter (where present) in the threaded hose fitting at the water inlet valve is blocked q The water inlet hose has not been correctly laid or it is bent or squashed q q Turn the water tap on q Clean the filter in the threaded hose q q Check the water drain hose connection q continuous flashing The dishwasher will of the light of the not drain running programme appears in the digital display continuous flashing Anti-flood device is of the light of the activated running programme appears in the digital display The sink spigot is blocked The water drain hose has not been correctly laid or it is bent or squashed q Clean out the sink spigot Check the water drain hose connection q q q q q Close the water tap and contact your local Service Force Centre q something not working electrolux 33 Fault code Malfunction The programme does not start q Possible cause The dishwasher's door has not been properly closed The main plug is not plugged in The fuse has blown out in the household fuse box Delay start has been set q Solution Close the door q q Insert the main plug Replace the fuse q q q q If dishes are to be washed immediately, cancel the delay start Once these checks have been carried out; close the dishwasher's door and switch on the appliance. Press the button of the programme that was running before the intervention of the alarm. The programme will continue from the point at which it was interrupted. If the malfunction or fault code reappears contact the Service Force Centre. [. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]