User manual AEG-ELECTROLUX ESF6549X

[. . . ] This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. Installation q Check your dishwasher for any transport damage. If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. [. . . ] Open the door, remove the lower basket and unscrew the cap of the salt container by turning it anticlockwise. Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time). Using the funnel provided, pour in the salt until the container is full. Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket. Screw on the cap tightly turning it clockwise until it stops with a click. LE SA UT ZO LT SA LZ SA L SE Setting the water softener 1. Remove the lower basket from the dishwasher. Turn the water hardness switch until the required level (see table) corresponds with the marker . The dishwasher is factory set at position 2. SR14 The salt container will require topping up periodically. The salt cap has a refill indicator window in the centre. Start the wash programme. Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. q q Before loading the dishes, you should: - Remove large left-overs. - Soften remnants of burnt food in pans When loading the dishes and cutlery, please note: - Dishes and cutlery must not impede the rotation of the spray arms . Prior to the start of a wash programme (not for the "Rinse and Hold" programme). The detergent is released during the washing phase. Please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. Fill with detergent 1. If the lid is closed: press release button (1). Fill the detergent dispenser (2) with detergent. The marking indicates the dosing levels: 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent Before closing the door, ensure that the spray arms can rotate freely. US74 Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Maximum height of the dishes in upper basket lower basket DE19 DE22 With upper basket raised With upper basket lowered 20 cm 24 cm 31 cm 27 cm 3. All programmes with prewash need an additional detergent dose (5/10 g) that must be placed in the prewash detergent chamber (3). This detergent will take effect during the prewash phase. Close the lid and press until it locks in place. To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. [. . . ] Check the water drain hose connection. The dishwasher will not drain. The water drain hose has not been correctly laid or it is bent or squashed. The dishwasher door has not been properly closed. The programme does not start The main plug is not plugged in. [. . . ]