User manual AEG-ELECTROLUX ESF6585RYW

[. . . ] Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. q Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. [. . . ] In this case the rinse aid compartment must be empty, in order to avoid a double dosage and the rinse aid indicator light deactivated. If in the rinse aid compartment there is still rinse aid you must wait until it has finished before using these kind of detergents. 3. All programmes with prewash need a little amount of detergent (5 g) to be added in the adjacent chamber (3). Close the lid and press until it locks in place. Fill with detergent (Detergent dispenser type B) 1. If the lid is closed: open the dispenser by pulling the catch (D). Fill the detergent dispenser with detergent. The marking indicates the dosing levels: Min = approximately 15 g of detergent Max = approximately 30 g of detergent 3. Close the lid and press until it locks in place. Use of "3 in 1" combi detergents General advice These products are detergents with integrated and combined detergent/rinse-aid and salt functions. Before using these products you should first check that the water hardness in your supply is compatible with the use of these products as per the detergent manufacturers (on the product packaging). These products should be strictly used according to the detergent manufacturers instructions. If you encounter problems when using 3 in 1 products for the first time then please contact the detergent manufacturers care line (the telephone number is given on the product packaging). Special advice Select "3IN1" push button. Press one of the programme selection push buttons and within 3 seconds select a washing programme. From the moment that the washing programme has been set, the delay start will begin with the countdown. The countdown will decrease with step of 3 hours. During the countdown, the indicator light of the selected programme and the indicator light of the number of hours to the start of the programme will remain illuminated. Once the delay start has elapsed the programme will start automatically, the indicator lights for delay start turn off and the indicator light of the phase underway illuminates. To change the "delay start" As long as the washing programme has not started, you can change the number of hours for the delay start by pressing the "delay start" push button. 6. To interrupt or cancel a washing programme Interrupt, change or cancel a washing programme in progress ONLY if it's absolutely necessary To cancel the "delay start" It is possible to cancel a countdown in progress or before it starts, simply pressing the delay start push button until the indicator lights corresponding to the delay start hours are off. The washing programme will start immediately. To interrupt a washing programme Attention!Hot steam may escape when the door is opened. q Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point in which it was interrupted. q pressing the On/Off (in this case all the indicator lights turn off). [. . . ] If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level. CS19 17 Water outlet hose connection The end of the drain hose can be connected in the following ways: 1. To the sink outlet spigot, securing it if necessary with a clip. Hooked over the edge of the sink using the special curved plastic guide provided. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. [. . . ]