User manual AEG-ELECTROLUX ESF66610K

[. . . ] It is imperative that these instructions are observed. This symbol or numbered instruction steps lead you step for step through the operation of the appliance. Next to this symbol you receive additional information and practical tips on using the appliance. Tips and instructions for the economical and environmentally conscious use of the appliance are marked with a clover leaf. 3 2 In the event of a malfunction, these operating instructions contain information on how to rectify faults yourself, see the "What to do, if. . . " section. [. . . ] egg white, egg yolk and mustard often cause discolouring and staining on silver. Therefore always clean left-overs from silver immediately, if it is not to be washed straight after use. ­ Some types of glass can become dull after a large number of washes. ­ Cutlery with wooden, horn, china or mother of pearl handles ­ Plastic items that are not heat resistant ­ Older cutlery with cement that is not temperature resistant ­ Bonded cutlery items or dishes ­ Pewter or copper items ­ Lead crystal glass ­ Steel items subject to rusting ­ Wooden platters ­ Items made from synthetic fibres · · Before loading the dishes, you should: ­ Remove large left-overs. ­ Soften remnants of burnt food in pans. When loading the dishes and cutlery, please note: ­ Dishes and cutlery must not impede the rotation of the spray arms. ­ Load hollow items such as cups, glasses, pans, etc. with the opening downwards so that water cannot collect in the container or a deep base. ­ Dishes and items of cutlery must not lie inside one another, or cover each other ­ To avoid damage to glasses, they must not touch ­ Do not lay small objects (e. g. lids) in the cutlery rack 11 Loading Cutlery 1 1 1 Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. To ensure that all items of cutlery are completely washed, you should 1. Press the button for the programme required (see , , Programme Table"). Press ON/OFF button Hot steam can escape when the door is opened. The programme switch rotates during the wash programme and indicates the position that has been reached in the programme. If a wash programme has been started even though the tap was closed, switch off the dishwasher with the ON/OFF button a, open the tap and start the wash programme again. 1 Changing/Interrupting the Wash Programme 3 Only change or interrupt a wash programme in progress if it is absolutely necessary. When the appliance is closed again, the air that has entered is heated rapidly and expands. This can cause water to escape onto the floor and possibly trigger the antiflood system. Changing the wash programme 1. Power indicator light goes out, wash programme stops. 1 2. 5. Hot steam can escape when the door is opened. Open dishwasher door and check whether there is still detergent in the container. Turn the programme switch clockwise to A, or B or C (see , , Programme Table"). Press the button for the programme required (see , , Programme Table"). 6. 16 Switching Off the Dishwasher When the wash programme is finished: 1. [. . . ] ­ Minimum required height 30 cm above the lower edge of the machine. Extension hoses · Extension hoses are available from your dealer or customer service. The internal diameter of the extension hoses must be 19 mm to ensure that the function of the appliance is not impeded. Extension hoses may be laid a maximum of 3 metres horizontally; the maximum permitted height for the connection for the drain hose is then 85 cm. · Siphon connection · The outlet of the drain hose (ø 19 mm) fits all commonly available siphon types. The outer diameter of the siphon connection must be at least 15 mm. [. . . ]