User manual AEG-ELECTROLUX ESF66710X

[. . . ] Safety information Product description Control panel First use Set the water softener Use of dishwasher salt Use of rinse aid Daily use Load cutlery and dishes Use of detergent Multi-tab function Select and start a washing programme 74 75 76 77 77 78 79 80 81 84 85 86 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Never lift or lower the basket on one side only When the basket is in the higher position cups cannot be placed on the cup racks. After loading your machine always close the door, as an open door can be a hazard. To move to the higher position proceed as follows: Only use detergents specifically designed for use in dishwashers. please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. Using no more than the correct amount of detergent contributes to reducing pollution. Fill the detergent dispenser (1) with detergent. Close the lid and press until it locks in place. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. The activation/deactivation of the rinse aid is only possible with the Multitab function active. Simultaneously press and hold function buttons B and C, until the lights of function buttons A , B, and C start flashing. Press function button B, the lights of function buttons A and C go off while the light of function button B continues to flash. To change the setting, press button B again, the digital display indicates the new setting. If you decide to revert back to the use of individual detergents we advise that you: 1. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. When a programme has been selected the corresponding light comes on. the programme in progress indicator light comes on. Close the dishwasher door, the programme starts automatically. Setting and starting the programme with delay start 1. Once selected the washing programme, press the delay start button until the flashing number of hours for the delay start appear in the digital display. The start of the selected washing programme can be delayed for between 1 and 19 hours. [. . . ] Water drain connection The end of the drain hose can be connected in the following ways: 1. to the sink outlet spigot , securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. [. . . ]