User manual AEG-ELECTROLUX ESI6200LOX

[. . . ] Put the knives and all items with sharp points in the cutlery basket with their points down. If not, put in a horizontal position in the upper basket. If you open the door while the appliance is in operation, hot steam can escape. ⷠDo not remove dishes from the dishwasher before the end of the washing programme. [. . . ] Do not use the appliance to clean objects that can absorb water (sponges, household cloths, etc. Before you load cutlery and dishes, do these steps: ­ Remove all food remainings and debris. While you load cutlery and dishes, do these steps: ­ Load hollow items (e. Cups, glasses and pans) with the opening down. ­ Make sure that water does not collect in the container or in a deep base. ­ Make sure that cutlery and dishes do not lie inside one another. ­ Make sure that cutlery and dishes do not cover other cutlery and dishes. ­ Make sure that glasses do not touch other glasses. Plastic items and pans with non-stick coatings can keep water droplets. Plastic items do not dry as well as porcelain and steel items. Make sure that the spray arms can move freely before you start a washing programme. Press the lid until it locks into position. Different brands of detergent dissolve in different times. Some detergent tablets do not have the best cleaning results during short washing programmes. Use long washing programmes when you use detergent tablets to fully remove the detergent. Some types of tablets can contain other agents. Do a check if these tablets are applicable for the local water hardness. refer to the instructions from the manufacturer. When you set the multitab function, it stays on until you deactivate it. the multitab function stops automatically the flow of rinse aid and salt. The rinse aid indicator light and salt indicator light are deactivated. The programme duration can increase if you use the multitab function. [. . . ] If you cannot find a solution to the problem yourself, contact the Service Force Centre. fault code and malfunction · The digital display shows The dishwasher does not fill with water Switch off the appliance before you do the below suggested corrective actions. Close the water tap and contact your local Service Force Centre. The digital display shows The dishwasher will not drain If the malfunction shows again, contact your Service Force Centre. [. . . ]