User manual AEG-ELECTROLUX ESI6221X

[. . . ] This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. Installation q Check your dishwasher for any transport damage. If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. [. . . ] The use of 50°C washing programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes; these wash programmes are specially matched to the dirt-dissolving properties of the enzymes in the concentrated detergent. For this reason 50°C wash programmes in which concentrated detergents are used can achieve the same results that can otherwise only be achieved using 65°C programmes. Special advice When using combination 3 in 1 products select the lowest possible setting for water hardness. If you decide to turn back to the use of the standard detergent system we advise that you: q q Refill both the salt container and rinse aid dispenser. Switch the water hardness setting to the highest possible position and run a normal washing programme without a load. Readjust the water hardness setting again according to the hardness of the water in your area. q Combi detergents If you are using dishwasher detergent that includes the rinse aid function, this must be placed in the detergent compartment. For best results we recommend the use of Finish detergents, rinse aid and salt. POURING EASY PACK TION DOUBLE AC FOR A BRILLIANT SHINE N EW LIQUID GEL POWDER RINSE C O N C E N T R AT E D D I S H WA S H E R D E T E R G E N T DE15 9 Washing programmes Programme Degree of soil and type of load Starting position of the programme selector dial Cycle description (3) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) (1) Normal 65°C with prewash Normal soil Crockery, cutlery, pots and pans 1 Cold prewash Main wash up to 65°C 1 cold rinse 1 hot rinse Drying Main wash up to 65°C 1 cold rinse 1 hot rinse Drying Main wash up to 65°C 1 hot rinse 102 - 115 1, 2 - 1, 3 14 - 15 Normal 65°C no prewash Normal soil Crockery and cutlery Fresh soil Crockery and cutlery Any. Partial load (to be completed later in the day). 2 90 - 100 1, 2 - 1, 3 11 - 12 (2) Quick 65°C 3 30 - 40 1, 1 - 1, 2 12 - 13 Rinse and hold 4 1 cold rinse (to avoid food scraps from sticking together). 10 0, 1 12 (1) (2) Testing programme for EN 50242 (see "Hints for Test Centres"). Ideal for washing crockery and cutlery of breakfast and dinner (fresh soil). Characterised by a duration of about 30 minutes and a washing temperature of 60°C. The time value is approximate and depends on the pressure and the temperature of the water and also by the variations of the power supply. This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply. (3) 10 Operating sequence 1. Put the filter combination in place and lock by turning the handle clockwise to the stop. During this process ensure that the flat filter does not protrude above the base of the washing compartment. Attention! Under no circumstances may the dishwasher be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters The filters in the base of the washing compartment are to a large extent self-cleaning. Nevertheless the filters should be checked and cleaned from time to time. Dirty filters will degrade the washing result. The dishwasher filter system comprises a coarse/fine filter (A/B), a microfilter (C) and a flat filter (D). Some dishwasher will only have a coarse filter (A), a microfilter (C) and a flat filter (D). Unlock the filter system using the handle on the microfilter, and remove. NEVER try to remove the upper spray arm. If residues of soil have clogged the holes in the upper spray arm, remove them with a toothpick. MA40 Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water. Leave the door ajar to prevent the formation of any unpleasant smells. [. . . ] To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. Hooked over the edge of the sink using the special curved plastic guide (if provided with the machine). To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. [. . . ]