User manual AEG-ELECTROLUX ESI6231X

[. . . ] D i s h w a s h e r User information ESI 6231 822 961 649-00-190706-01 g Dear Customer, Please read these user instructions carefully and keep them to refer to later. Please pass the user instructions on to any future owner of the appliance. The following symbols are used in the text: 1 Safety instructions 3 Useful tips and hints 2 Environmental information Warning!Information that affects your personal safety. Information that prevents damage to the appliance. 2 Contents Operating Instructions . [. . . ] The selected dishwashing cycle will begin immediately. To change a dishwashing cycle As long as the cycle has not yet started, you can still change the dishwashing cycle. First abort the dishwashing cycle, then re-set the time delay, lastly select the new dishwashing cycle. Interrupting or aborting a dishwashing cycle Only interrupt a dishwashing cycle that is in progress if it is absolutely necessary. Interrupting the dishwashing programme by opening the dishwasher door opened. There is a risk of scalding. Switching off the dishwasher Do not switch off the dishwasher until the indicator for the end of the dishwasher cycle is illuminated in the cycle progress display. With some dishwashing cycles, the drying fan continues to run even after the end of the cycle. 2. Turn off the water tap. 1 Hot steam may escape when the door is 1. The cycle will continue. Aborting the dishwashing cycle 1. Press function buttons 2 and 3 and keep them pressed. The programme display for the current cycle will flash for several seconds and then go out. The dishwashing cycle has been cancelled. If you want to start a new cycle, check whether there is any detergent in the dispenser. 1 Carefully open the door. Hot steam may escape. · Hot dishes are sensitive to knocks. Therefore leave the dishes to cool for about 15 minutes before removing them. · Dishes dry more quickly if you open the door for a moment after the cycle has ended and then leave it slightly open. 3 Turning off the dishwasher will only interrupt a selected dishwashing cycle, not cancel it. The cycle will recommence after turning the dishwasher back on again. Removing the dishes 3 It is normal for the inner door and the dispensers to be damp. · Empty the lower basket first, then the upper basket. This way you avoid dripping water from the upper basket onto dishes in the lower basket. Setting the Delay Timer Using the delay timer you can delay the start of a dishwashing cycle for 3, 6 or 9 hours. Press the Delay Timer button repeatedly until the indicator next to the number of hours for which the start of the dishwashing cycle is to be delayed lights up, e. 6h, if the cycle is to start in 6 hours. The LED indicator for the programme selected and the indicator next to the number of hours will light up. The dishwashing cycle will start automatically following a countdown of the hours set. 20 Care and cleaning 1 Do not use furniture care products or aggressive cleaners. · When necessary, clean the dishwasher's controls with a soft cloth and clean warm water. · Occasionally check the internal dispensers, door seal and water inlet filter (if fitted) for dirt and clean them, if necessary. Cleaning the filters 3 The filters must bewillregularly checked and cleaned. [. . . ] If you need a longer water inlet hose than that supplied, the following VDE-approved complete hose sets are to be used. These are available from your local dealer. ­ Hose kit "WRflex 100" (Code: 911 239 034) ­ Hose kit "WRflex 200" (Code: 911 239 035) Water drainage Drain hose entangled. Connecting the drain hose: ­ Maximum permitted height: 1 metre. [. . . ]