User manual AEG-ELECTROLUX ESI692

[. . . ] We promise that it'll make your life a little easier. Good luck! The following symbols are used in this user manual: 117979510 - 092007 Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information 4 electrolux Contents Safety information Product description Control panel First use Set the water softener Use of dishwasher salt Use of rinse aid Daily use Load cutlery and dishes Use of detergent Multi-tab function Select and start a washing programme 5 7 8 10 10 12 13 14 15 19 20 22 Unloading the dishwasher Washing programmes Care and cleaning What to do if. . . Technical data Hints for test institutes Installation Water connection Electrical connection Environment concerns 24 24 26 28 31 31 32 33 35 36 safety information electrolux 5 Safety information · Do not take any dishes out of the dishwasher before the end of the washing cycle. [. . . ] Fill up the rinse aid dispenser with rinse aid. · The activation/deactivation of the rinse aid can only be possible with the Multitab function active. Activate/deactivate the ''Multitab function'' before the start of a washing programme. Once the programme is running, the "Multitab function " can NO longer be changed. If you want to exclude the "Multitab function " you have to cancel the programme setting and then deactivate the ''Multitab function''. In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the rinse aid dispenser 1. Simultaneously press and hold function buttons B and C, until the lights of function buttons A , B, and C start flashing. Press function button B, the lights of function buttons A and C turn off while the light of function button B goes on flashing. The digital display indicates the current setting. 22 electrolux select and start a washing programme Rinse aid dispenser deactivated Rinse aid dispenser activated 4. To change the setting, press button B again, the digital display indicates the new setting. To memorise the operation, switch off the dishwasher by pressing the On/Off button. Fill up the salt container and the rinse aid dispenser again. Hot steam may escape when the door is opened. Open the door carefully. Cancel a delay start or a washing programme in progress · Simultaneously press and hold the two Cancel buttons (function buttons B and C) until all the programme lights illuminate. · Cancelling a delay start involves also the cancelling of the washing programme set. In this case you have to select the washing programme again. · If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. 5. With the delay start function set, the programme in progress indicator light is off. Once the countdown of the delay start has elapsed, the washing programme will start automatically and the programme in progress indicator light will illuminate. End of the washing programme · The dishwasher will automatically stop and the programme in progress indicator light turns off. · The End indicator light will illuminate. · The light of the programme just ended will remain on. · Zero appears in the digital display. Switch off the dishwasher by pressing the On/Off button. Open the dishwasher door, leave it ajar and wait a few minutes before The selection of the washing programme and delay start can also occur with the door closed. [. . . ] To a stand pipe provided with venthole, minimum internal diameter 4 cm. The waste connection must be at a maximum height of 60 cm from the bottom of the dishwasher. Water inlet hose with safety valve After connecting the double-walled water inlet hose, the safety valve is next to the tap. Therefore the water inlet hose is only under pressure while the water is running. If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water. [. . . ]