User manual AEG-ELECTROLUX ESL4160

[. . . ] You MUST read it carefully before installing or using the appliance. Installation q q When finishing loading or unloading close the door, as an open door can be a hazard. Isolate the appliance from the power supply and turn off the water supply after use. Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. [. . . ] Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker on the control panel. Important!Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. 9. Start the programme Depress the On/Off push button and close the door, the machine will start. If you wish to interrupt the washing programme at any time open the door and press this button again. 13 Maintenance and cleaning Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend the use of Finish Dishwasher Cleaner every 3 months or run a 65°C wash without dishes using detergent. Regular use of Finish Dishwasher Cleaner cleans inaccessible parts, eliminates unpleasant food odours and helps prevent the build-up of limescale. D C B Cleaning the central filters (After each wash) Inspect the central filters (B) and (C) and remove any scraps of food with a brush, under running water. Filters (B) and (C) are both removed by lifting up the outer one (B) (pulling the central funnel upwards); the smaller filter (C) can be removed by pressing the two tongues (D). Once cleaned, refit the filters by pressing them down until they click into place. MA02 MA08 Cleaning the large filter (every week) Clean the large filter (A) on both sides under running water, using a brush. To take it out, remove the spray arm by pressing the two tongues (E), turn the ring (F) anticlockwise and then slide the whole part out. Refit the filter following the above instructions in reverse order. E A F MA03 The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. 14 External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. The dishwasher is not level, or not properly built-in. Check that there is salt and that the salt cap is tight. Check that the right level of the water softener is set. The rinse aid has run out or too little is being used. The dishes have not been arranged properly. The spray arms do not rotate The spray arms are clogged. The filters are not in the correct position. Not enough detergent has been used or it is unsuitable. The salt container cap is not properly closed. The washing programme selected is too gentle. The machine does not fill with water q q q q The filters are blocked The spray arms are not rotating The dishwasher will not drain q q q q q q The machine is noisy q q The door is difficult to close Visible lime deposits or white film on the dishes The dishes are not quite dry The dishes are not clean (poor wash) q q q q q q q q q q q q q q 16 If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number. This information can be found on the rating plate located on the right hand side of the dishwasher door (see picture). [. . . ] It is essential that the recess dimensions indicated in the diagram are followed. No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through. The recess height may be anywhere between 820 and 880 mm from the floor as the dishwasher incorporates adjustable feet (max 60 mm). 818 - 878 446 A distance of 2 mm should be allowed between the top of the dishwasher and the counter top. 5 55 x ma 450 Adjusting the height of the appliance To adjust the height proceed as follows: 1. The rear foot is adjusted by turning the screw in the middle of the front kick plate to the left or right. [. . . ]