User manual AEG-ELECTROLUX ESL6231

[. . . ] If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. Any electrical and plumbing work required to install this appliance should be carried out by a qualified and competent person. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. [. . . ] NOTE: If the drying results are not satisfactory we recommend that you: 1. Fill up the rinse aid dispenser with rinse aid. Set the rinse aid dosage to position 2. If you decide to turn back to the use of the standard detergent system we advise that you: q q Fill up the dispensers for salt and rinse aid again. Adjust the water hardness setting to the highest setting perform up to 3 normal washing programmes without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Adjust the rinse aid dosage. q q NOTE: When using 4 in 1 detergent tablets that integrate also anti-glass corrosion agent into "3 in 1" formula, please follow the same instruction as given for "3 in 1" detergents above. 10 Washing Programmes Programme Degree of soil and type of load Press the programme button Cycle description (2) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) Anti+Bac 70° Heavy soil. Crockery, cutlery, pots and pans 70° Hot prewash Main wash up to 70°C 2 warm rinses 1 hot rinse Drying Cold prewash Main wash up to 65°C 1 cold rinse 1 hot rinse Drying Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse Drying Main wash up to 60°C 1 hot rinse 1 cold rinse (to avoid food scraps from sticking together). This programme does not require the use of detergent. 120 - 130 1. 7 - 1. 9 23 - 25 Normal 65° Normal soil. Crockery and cutlery 65° 95 - 105 1. 3 - 1. 5 19 - 21 (1) Normal-Eco 50° Normal soil. Crockery and cutlery 50° 90 0, 6 16 - 17 Quick 30I 60° Light soil. Crockery and cutlery 60° 30 0. 8 9 Rinse Any. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Setting and starting the programme with delay start Press the button corresponding to the required programme (see "Washing programmes" chart). Press the Delay button until the indicator light corresponding to the chosen hours flashes (3h, 6h or 9h). Close the dishwasher door, the countdown starts automatically and will decrease with steps of 3 hours. The opening of the door will not modify or interrupt the countdown. Once the delay start has elapsed the programme will start automatically. NOTE: the start of the programme or the countdown of the delay start will occur only after the closure of the dishwasher door, until this moment it is possible modify the set made. 5. To interrupt or cancel a washing programme in progress Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary Attention!Hot steam may escape when the door is opened. Open the door carefully. Interrupt a washing programme in progress Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. Cancel a washing programme in progress Open the dishwasher door. Press simultaneously function buttons 2 and 3 for about 2 seconds, the indicator light of the button corresponding to the running programme starts flashing. 12 Maintenance and Cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. [. . . ] Electrolux is not liable in the following situations (which are not exhaustive): (a) The Appliance is damaged by: (i) accident (ii) misuse or abuse, including failure to properly maintain or service (iii) normal wear and tear (iv) power surges, electrical storm damage or incorrect power supply (v) incomplete or improper installation (vi) incorrect, improper or inappropriate operation (vii) insect or vermin infestation. (b) The Appliance is modified without authority from Electrolux in writing. (c) The Appliance's serial number or warranty seal has been removed or defaced. (d) The Appliance was serviced or repaired by anyone other than Electrolux or its Authorised Service Centres. [. . . ]