User manual AEG-ELECTROLUX ESL624

[. . . ] Dishwasher INSTRUCTION BOOK Model ESL 624 UK 152983 64/2 Contents For the user Important safety information Description of the appliance The control panel Before use Setting the water softener Filling with salt Rinse aid Using your appliance Loading your appliance The lower basket The cutlery basket The upper basket Adjusting the height of the upper basket Use of detergent Hints and tips Washing programmes Operating sequence Maintenance and cleaning Internal cleaning Cleaning the central filter Cleaning the large filter External cleaning Prolonged periods of non-operation Frost precautions Moving the machine Something not working Service and spare parts Customer Care Department Guarantee conditions Electrolux Service Force Hints for test centres Technical specifications 3 4 4 5 5 6 7 8 8 8 8 9 9 10 11 12 13 14 14 14 14 15 15 15 15 16 17 17 18 19 21 21 For the installer Installation instructions Water supply connections Water outlet hose connection Electrical connection Building-in 22 22 23 24 25 Guide to use the instruction book The following symbols will be found in the text to guide you throughout the instructions: Safety instructions 1. Step by step Hints and tips Environmental information 2 Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety. [. . . ] If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Remove the water inlet and discharge hoses. Pull the machine out together with the hoses. Avoid over tilting the machine during transportation. 15 Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation a charge will be made even if the appliance is in guarantee. Symptom The machine will not start q q q Solution The door has not been properly closed. The plug is not properly inserted in the power socket. Ensure the mains water supply has not been cut off. Switch off the water supply and clean the filter. Clean the filters (refer to "Maintenance and cleaning"). Ensure the crockery is loaded correctly. The drain hose extension is not correct. Follow the instructions for connecting to the waste. There is no vent in the end of the drain hose. Dishes are rattling against each other, refer to "Loading your machine". The spray arms are knocking against the dishes. Refer to "Loading your machine". [. . . ] No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through. 818 - 878 596 5 57 x ma 0 5 55 x ma The recess height may be anywhere between 820 and 880 mm from the floor as the dishwasher incorporates adjustable feet (max 60 mm). A distance of 2 mm should be allowed between the top of the dishwasher and the counter top. - 600 + II76 Adjusting the height of the appliance To adjust the height proceed as follows: 1. The rear foot is adjusted by turning the screw in the middle of the front kick plate to the left or right. A pad is supplied for the rear foot to make sliding the appliance in and out of the recess easier. [. . . ]