User manual AEG-ELECTROLUX ESL664

[. . . ] You MUST read it carefully before installing or using the appliance. Installation q q q Do not sit or stand on the open door. Isolate the appliance from the power supply and turn off the water supply after use. Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. [. . . ] Arrange items on and underneath the fold-down cup racks so that water can reach all surfaces. Light items (plastic bowls etc. ) should be loaded in the upper basket and arranged so they do not move. Before closing the door, ensure that the spray arms can rotate freely. US29 US70 Adjusting the height of the upper basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position. To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. RC01 A When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. After loading your machine always close the door, as an open door can be a hazard. 9 Use of detergent Only use detergents specifically designed for use in dishwashers. If using powder detergents proceed as follows: 1. Open the dispenser lid by pulling the catch (D). Add the detergent according to the recommended quantity given in the "Washing programmes" chart. As all detergents are not the same, you should consult the instructions on the packet. If the programme has a prewash add the required detergent over the lid of the dispenser. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 5. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the dosage quantity given in the "Washing programmes" chart. Close the detergent dispenser lid. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working;if the door is opened however, a safety device ensures that the machine stops. 7. Set the programme The selection of the programme occurs with the door partially opened. Depress the programme button which corresponds to the washing programme you wish to select, the corresponding indicator light will flash. Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. 8. Start the programme Close the dishwasher door. An audible signal advises you that the programme has started. The indicator light which corresponds to the programme under way is now permanently on. How to cancel a wash programme q If the door has not been closed and the wash programme has not started, to cancel the programme simply press the push button of a different wash programme. [. . . ] Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. Remove all packaging before positioning the machine. If possible, position the machine next to a water tap and a drain. Water supply connections This dishwasher may be fed with either hot (max. Nevertheless we advise a cold water supply. A hot water supply is not always efficient with very soiled crockery as it shortens the washing programmes. [. . . ]