User manual AEG-ELECTROLUX ESL67930

[. . . ] We promise that it will provide a superior User Experience delivering Ease-of-Mind. Good luck! 4 electrolux contents Contents Safety information Product description Control panel First use Daily use Washing programmes Care and cleaning Something not working Technical data Hints for test institutes Installation Environment concerns Guarantee/Customer Service 5 7 8 12 16 28 30 32 35 37 38 42 43 The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information safety information electrolux 5 Safety information q In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. [. . . ] If the appliance is partially loaded and the dishes lightly soiled, the "prewash", "main wash", and "rinse" phases of the programme are shorter and the water consumption level is lower. If the appliance is fully loaded and the dishes heavily soiled, the "prewash", "main wash", and "rinse" phases of the programme are longer and the water consumption level is higher. For this reason the programme duration, water and energy consumption levels can vary within the stated range for "Auto" programme. During the "Auto" programme the temperature of the main wash water is also automatically adjusted between 50C and 65C depending on the amount of soil on the dishes. 30 electrolux care and cleaning Care and cleaning Cleaning the filters The filters must be checked and cleaned from time to time. Dirty filters will degrade the washing result. Take hold of the coarse filter (A) by the handle with the hole and remove from the microfilter (B). Clean all filters thoroughly under running water. Remove the flat filter from the base of the washing compartment and clean both faces thoroughly. Before cleaning the filters ensure that the machine is switched off. The dishwasher filter system comprises a coarse filter (A), a microfilter (B) and a flat filter. Unlock the filter system using the handle on the microfilter, and remove. 7. Put the flat filter back in the base of the washing compartment and ensure that it fits perfectly. The filter (where present) in the threaded hose fitting at the water inlet valve is blocked. The water inlet hose has not been correctly laid or it is bent or squashed. The water drain hose has not been correctly laid or it is bent or squashed. Check the water drain hose connection. q q The dishwasher does not fill with water q q continuous flashing of the light of the running programme, point-shaped optical signal is flashing, appears in the digital display, intermittent audible signal, q q q q q The dishwasher will not drain q continuous flashing of the light of the running programme, point-shaped optical signal is flashing, appears in the digital display, intermittent audible signal, q Close the water tap and contact your local Service Force Centre. q q q Anti-flood device is activated Remember to switch off the appliance before carrying out any corrective action. something not working electrolux 33 The flashing of the point-shaped optical signal on the floor beneath the dishwasher's door will not be visible if the appliance has been installed higher up with a furniture door mounted flush. Malfunction The programme does not start q Possible cause and solution The dishwasher's door has not been properly closed. The fuse has blown out in the household fuse box. If dishes are to be washed immediately, cancel the delay start. q q q Once these checks have been carried out; switch on the appliance, press the button of the programme that was running before the intervention of the alarm and close the dishwasher's door. The programme will continue from the point at which it was interrupted. If the malfunction or fault code reappears contact the Service Force Centre. For other fault codes not described in the above chart, please contact your Service Force Centre. Contact your local Service Force Centre, quoting the model (Mod. ), product number (PNC) and serial number (S. N. ). This information can be found on the rating plate located on the side of the dishwasher door. So that you always have these numbers at hand, we recommend you to make a note of them here: Mod. [. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]