User manual AEG-ELECTROLUX ESL90600X

[. . . ] If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. Any electrical and plumbing work required to install this appliance should be carried out by a qualified and competent person. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. [. . . ] Crockery, cutlery, pots and pans AUTO 65°-50° 1. 65 - 2. 0 20 - 30 (2) Normal-Eco 50° Normal soil. Crockery and cutlery 50° 1, 6 19 Quick 40I 60° Light soil. Crockery and cutlery 60° 1 10 Rinse Any. Partial load (to be completed later in the day). 0. 1 4 (1) Auto 65°-50° washing programme During the Auto 65°-50° washing programme the amount of soil on the dishes is determined by how cloudy the water is. If the appliance is partially loaded and the dishes lightly soiled, the «prewash», «main wash», and «rinse» phases of the programme are shorter and the water consumption level is lower. If the appliance is fully loaded and the dishes heavily soiled, the «prewash», «main wash», and «rinse» phases of the programme are longer and the water consumption level is higher. During the Auto 65°-50° programme the temperature of the main wash water is also automatically adjusted between 50°C and 65°C depending on the amount of soil on the dishes. This programme is recommended to wash a normally soiled load of 9 place settings. (3) The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply. The programme duration is visible in the digital display when the selection of the washing programme occurs. Note: Anti+Bac function gives a greater degree of hygiene to dishes and glasses. In the last rinse the temperature will be held at over 65°C for at least 10/11 minutes. 11 Starting a Washing Programme In this fully integrated appliance the controls are located on the top of the door. Unloading the dishwasher Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. NOTE: The start of the programme or the countdown of the delay start will occur only after the closure of the door, until this moment it is possible to modify the set made. 5. To interrupt or cancel a washing programme in progress Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary. Hot steam may escape when the door is opened. Open the door carefully. Interrupt a washing programme in progress Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. Cancel a washing programme in progress Open the dishwasher door. Press simultaneously function buttons 2 and 3 for about 2 seconds, the indicator light of the button corresponding to the running programme starts flashing. 12 Maintenance and Cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. [. . . ] Electrolux is not liable in the following situations (which are not exhaustive): (a) The Appliance is damaged by: (i) accident (ii) misuse or abuse, including failure to properly maintain or service (iii) normal wear and tear (iv) power surges, electrical storm damage or incorrect power supply (v) incomplete or improper installation (vi) incorrect, improper or inappropriate operation (vii) insect or vermin infestation. (b) The Appliance is modified without authority from Electrolux in writing. (c) The Appliance's serial number or warranty seal has been removed or defaced. (d) The Appliance was serviced or repaired by anyone other than Electrolux or its Authorised Service Centres. [. . . ]