User manual AEG-ELECTROLUX ETN1001

[. . . ] correct use · This dishwasher is only intended for washing household utensils suitable for machine washing. ⷠDo not put any solvents in the dishwasher. Knives and other items with sharp points must be loaded in the cutlery basket with their points down or placed in a horizontal position in the upper basket. Avoid opening the door whilst the appliance is in operation, hot steam may escape. [. . . ] ) must be loaded in the upper basket and arranged so they do not move. For washing in the dishwasher the following cutlery and dishes are of limited suitability: · Cutlery with wooden, horn, china or mother-of- · Plastic items that are not heat resistant. Older cutlery with glued parts that are not tem- · Silver and aluminium parts have a tendency to · White, egg yolk and mustard often cause dis· Ways clean left-overs from silver immediately, if · items made from synthetics fibres. It is not to be washed straight after use. The lower basket The lower basket is designed to take saucepan, lids, plates, salad bowls, cutlery etc. Service dishes and large lids should be arranged around the edge of the basket, ensuring that the spray arms can turn freely. The rows of prongs in the lower basket can lie flat to allow you to load pots, pans and bowls. Take care when loading or unloading sharp items such as knives. Forks and spoons should be placed in the removable cutlery basket with the handles facing downwards and the knives with their handles facing upwards. for best results we recommend that you use the cutlery grids. If the size and dimensions of the cutlery do not allow the use of the grids, they can be easily hidden. Close the door, the programme will continue from the point at which it was interrupted. The appliance stops automatically and an audible signal informs you of the end of the washing programme. Leave the door ajar and wait a few minutes before removing the dishes. This way they will be cooler and the drying will be improved The dishes should therefore be allowed to cool down before removing from the appliance. ⷠEmpty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. ⷠWater may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Programme description Prewash Main wash up to 45°C or 70°C 1 or 2 intermediate rinses Final rinse Drying Main wash up to 60°C Final rinse Prewash Main wash up to 70°C Intermediate rinse Final rinse Drying Prewash Main wash up to 65°C Intermediate rinse Final rinse Drying Prewash Main wash up to 50°C Intermediate rinse Final rinse Drying Prewash Main wash up to 50°C Intermediate rinse Final rinse Drying Main wash up to 45°C Intermediate rinse Final rinse Drying 1 cold rinse (to avoid food scraps from sticking). This programme does not require the use of detergent. 1) During the AUTOMATIC washing programme the level of soiling on the dishes is determined by how cloudy the water is. The programme duration, water and energy consumption levels can vary; this depends upon if the appliance is fully or partially loaded and if the dishes are lightly or heavily soiled. [. . . ] If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water. Please take care when installing the water inlet hose: · the electrical cable for the safety valve is in the double-walled water inlet hose. Do not immerse the water inlet hose or the safety valve in water. A water inlet hose with safety valve must only be replaced by the Service Force Centre. [. . . ]