User manual AEG-ELECTROLUX ETN1042V

[. . . ] Failure to observe the warning could result in injury or damage to the appliance. Failure to observe the warning could result in scalds or burns. Important information for the user Danger!This is an electrical appliance, it is therefore important to respect the following safety warnings: · Never touch the appliance with damp hands. [. . . ] Take a container, fill it with about 100 g of milk for each cappuccino to be made and place it under the cappuccino maker. In choosing the size of the recipient, bear in mind that the milk doubles or triples in volume. You are recommended to use partially skimmed milk at refrigerator temperature. "STEAM PRESS OK" is displayed. To interrupt steam delivery, press the icon (B12) again or the ESC icon (B6). Immerse the cappuccino maker in the milk container (fig. 23), taking care not to immerse it for more than half its length. Press the icon (B12) (take care to avoid scalds) and press the OK icon (B9). Steam comes out of the cappuccino maker. For a creamier froth, immerse the cappuccino maker in the milk and move the container with slow upward movements. You should not deliver steam for more than 2 minutes at a time. Make sure the water tank is full, the bean container is full enough and the waste coffee container is completely empty. The type of coffee selected, for example "EXTRA-MILD JUG", and the number of cups you want to make with the jug are displayed, for example "JUG 4 CUPS". The display shows a progress bar which indicates coffee making process. When the progress bar is complete, the appliance finishes the process and automatically goes back to the coffee jug function. If on the other hand an incomplete progress bar is displayed, this means that the cycle has not been completed correctly. Remove the jug and check the message which appears on the display, consulting the section "DISPLAYED MESSAGES". Remove jug and leave the lid in the CLOSE position to keep the coffee hot. To pour the coffee, turn the lid anticlockwise until the arrow is lined up with the spout of the jug. Important!When the coffee beans are insufficient to complete the required function, the appliance stops the process and waits for the bean container to be filled again and the icon (B14) to be pressed. For example, when you want to make 4 cups of coffee but the beans are 17 GB insufficient, the appliance makes 2 cups then stops making coffee. Fill the bean container and press the icon (B14). [. . . ] Important: when removing the drip tray, the waste coffee container MUST be emptied, even if it is not completely full. If this is not done, when you make the next coffees, the waste coffee container may fill up more than expected and clog the machine. Open the service door and insert the waste coffee container. INSERT WASTE COFFEE CONTAINER · After cleaning, the waste coffee container has not been replaced. 25 · GB DISPLAYED MESSAGE ADD PRE-GROUND COFFEE · POSSIBLE CAUSE The "pre-ground coffee" function has been selected without placing any pre-ground coffee in the funnel. [. . . ]