User manual AEG-ELECTROLUX ETN1061H

[. . . ] Failure to observe the warning could result in injury or damage to the appliance. Failure to observe the warning could result in scalds or burns. Important information for the user Danger!This is an electrical appliance, it is therefore important to respect the following safety warnings: · Never touch the appliance with damp hands. [. . . ] NOTE 1: While making cappuccino, the flow of frothed milk or coffee can be interrupted by pressing the icon (B12). NOTE 2: If the milk in the container finishes while delivering frothed milk, remove the container and add milk. Then re-attach it and press the icon (B12) to request cappuccino again. NOTE 3: To ensure the complete cleanliness and hygiene of the milk frother, always clean the circuits in the milk container lid after making cappuccino. "PRESS CLEAN!" flashes on the display. · Place a recipient under the milk spout (fig. · Press the CLEAN button on the lid (C3) and hold down for at least 5 seconds (fig. The appliance displays the message "CLEANING" above a progressive bar. You should not release the CLEAN button until the bar is complete indicating that cleaning is concluded. When the CLEAN button is released, the function stops. After cleaning, remove the milk container and place in the refrigerator. The display shows a progress bar which indicates coffee making process. When the progress bar is complete, the appliance finishes the process and automatically goes back to the coffee jug function. If on the other hand an incomplete progress bar is displayed, this means that the cycle has not been completed correctly. Remove the jug and check the message which appears on the display, consulting the section "DISPLAYED MESSAGES". Remove jug and leave the lid in the CLOSE position to keep the coffee hot. To pour the coffee, turn the lid anticlockwise until the arrow is lined up with the spout of the jug. · The coffee spout (A13) must be fully raised to enable the jug to be inserted. AND WATER TANK, EMPTY WASTE CONT. , PRESS OK" is displayed. Make sure the water tank is full, the bean container is full enough and the waste coffee container is completely empty. The type of coffee selected, for example "EXTRA-MILD JUG", and the number of cups 18 Important!When the coffee beans are insufficient to complete the required function, the appliance stops the process and waits for the bean container to be filled again and the icon (B14) to be pressed. For example, when you want to make 4 cups of coffee but the beans are insufficient, the appliance makes 2 cups then stops making coffee. [. . . ] If the message is still displayed after cleaning, contact a customer services. You must immediately replace the filter following the instructions in the section "Replacing the filter". PLEASE DESCALE!(alternating with) MEDIUM CUP NORMAL TASTE · The machine must be descaled. · LESS COFFEE · Too much coffee has been used. · FILL BEAN CONTAINER · The coffee beans have run out. The brewing unit has not been replaced after cleaning. [. . . ]