User manual AEG-ELECTROLUX ETN1062V

[. . . ] The refrigerant isobutane (R600a) is contained within the refrigerant circuit of the appliance, a natural gas with a high level of environmental compatibility, which is nevertheless flammable. During transportation and installation of the appliance, be certain that none of the components of the refrigerant circuit become damaged. If the refrigerant circuit should become damaged: ­ avoid open flames and sources of ignition ­ thoroughly ventilate the room in which the appliance is situated · It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. [. . . ] Excessive heat may damage the plastic interior, and humidity could enter the electric system making it live. For electrical connection carefully follow the instructions given in specific paragraphs. Report possible damages immediately to the place you bought it. It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the compressor. ⷠAdequate air circulation should be around the appliance, lacking this leads to overheating. Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn. ⷠThe appliance must not be located close to radiators or cookers. ⷠMake sure that the mains plug is accessible after the installation of the appliance. Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. ⷠThis product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The thermic dilatation might cause a sudden cracking noise. When the compressor switches on or switches off, you will hear a faint "click" of the temperature regulator. Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time Electrolux 5 the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. ⷠPut insulating material around the drawers, e. Defrosting can be accelerated by placing bowls with hot water (not boiling) inside the freezer. ⷠLoosen the drainage channel from its resting position, push it in according to the illustration and place it in the bottom freezer drawer where water can collect · Carefully scrape off the ice when it starts to thaw. [. . . ] This can be achieved by two adjustable feet at the bottom in front. Electrolux 7 Removing the shelf holders Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. Raise the shelf from the rear and push it forward until it is freed (B). Before carrying out any operations, remove the plug from the power socket. [. . . ]