User manual AEG-ELECTROLUX ETNK 1224

[. . . ] liquids will freeze and burst the bottle. Make sure that the electricity supply to the Never use a naked flame or heater/hairdryer for appliance has been isolated during repairs and defrosting purposes. If you use a casserole dish maintenance work by removing the plugs from with hot water, the dish should not touch the the wall sockets or removing the fuse from the plastic sides or the bottom of the refrigerator. frozen produce should be well-insulated during The minikitchen is heavy take care when defrosting in order to minimise any temperature moving it. [. . . ] The various types of plastic are marked and can be recycled: `PE' stands for polyethylene and concerns the bag for the user manual. `PS' stands for extruded polystyrene and concerns the impact-absorbing packaging components. The packaging is made from recyclable materials and should be delivered to a recycling centre. symbol on the product or packaging states The that the product may not be treated as household waste. It should instead be delivered to a recycling centre for the recycling of electrical and electronic components. By ensuring that the minikitchen is disposed of in the right way, you contribute towards preventing negative environmental and health effects that could result if the appliance is disposed of as ordinary waste. For more information about recycling, contact your local authority or refuse collection service or the shop where you bought the appliance. Height adjustment: Has been done at the factory (screws C + a concealed locking screw). Removing the doors: This is easily done using the quick-release function at the rear of the hinge. -5- Use Refrigerator Turn the thermostat control to an middel setting and then re-adjust to a temperature of +5°C after a few days if necessary. The right-hand numbers on the control correspond to the lower temperature in the refrigerator. Using the timer function All minikitchens with a glass ceramic hob also have an inbuilt timer function. The heating zones cannot become hot until a time has been set on the timer. The timer can be set to a maximum of 60 min. If you need the heating zones to be switched on for longer, e. g. when cooking something that takes a long time, you will have to reset the required time on the timer. You can also set the required time on the timer if you want the heating zones to switch off automatically. After you have set the timer, set the required heat setting using the heating zone knob. At the end of the preset time, the zone will be switched off and the indicator light will go out. Remember to reset the heating zone knob to zero when you have finished using the appliance. Glass ceramic hob The glass ceramic hob has two heating zones and a heat warning indicator. During use, the heating zones will fluctuate on and off in order to maintain the set temperature. The heating zones will switch on and off for varying lengths of time depending on the temperature selected. A high heat will result in longer periods when the power is switched on. However, even on the maximum setting, the zones will be switched on and off by an overheating safety device when the heat becomes too high/low. The heat warning indicator consists of two lights, which light up when the corresponding zone is too hot to touch. The hob has two heating zones, which are adjusted by turning the knob which has 13 settings - 12 temperature settings and a `0' position. [. . . ] The maximum power consumption is therefore 2300W. The water and waste water systems should be installed by an authorised plumbing and sanitary engineer. The external diameter of the waste water connection is 50mm. Damage caused by incorrect installation is not covered by the guarantee. Setting up The minikitchen should not be placed in a corridor or anywhere else where it will be passed frequently. [. . . ]