User manual AEG-ELECTROLUX EU0941T

[. . . ] It is dangerous to alter the specifications or attempt to modify this product in any way. Ensure that the appliance does not stand on the electrical supply cable. If the supply cord is damaged, it must be replaced by a special cord available from your local Service Force Centre. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ] Do not remove items from the freezer if your hands are damp/wet, as this could cause skin abrasions or 'frost/freezer burns'. For safety reasons, the freezer baskets are fitted with stops but are readily removed by pulling them forward to the stop, then lifting the front and pulling all the way out. Re-fit by reversing this procedure. Do not place sealed containers or carbonated liquids such as fizzy drinks into the freezer as it creates pressure on the container which may cause it to explode resulting to damage to the freezer. Ice cubes and ice lollies should not be consumed immediately after removal from the freezer as it may result in low temperature skin abrasions. Manufacturers storage times should be adhered to. Hints and Tips Any opened packets of frozen food, should be rewrapped in airtight materials to prevent surface evaporation which causes drying or 'freezer burn'. Frozen food which is allowed to thaw accidentally should either be used immediately or thrown away. Alternatively if the food is uncooked and has not been completely defrosted it can be cooked and then refrozen. Aim to check dates on packets and rotate food regularly. Although storage longer than recommended is not harmful, flavours and textures begin to change. 8 HINTS AND TIPS Normal Operating Sounds You may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear, to the cooling plate/evaporator or to the fixed freezer shelves. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor. A thermostat controls the compressor, and you will hear a faint 'click' when the thermostat cuts in and out. Locate the appliance in a cool well ventilated room and make sure that the air openings of the cabinet are not obstructed. Avoid unnecessary frosting in the cabinet by packing all foodstuffs into airtight packages before placing them in the freezer. 9 MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out DISCONNECT the appliance from the ELECTRICITY supply. Internal Cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0. 5 litre of water). If so leave for a few minutes to allow the air pressure to equalise. The compressor runs continuously Adjust the thermostat to give correct temperature control. Large quantities of food have recently been placed in the cabinet / and or door is frequently opened. Check that air ventilation is not obstructed. Excessive frost and ice has built up Ensure the door is not left open. Check that nothing is preventing the door from closing. Has advised periodic defrosting been carried out. Noise Refer to normal operating sounds. If after the above checks there is still a fault call your local Service Force Centre. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. Please note that proof of purchase is required for in-guarantee service calls. 11 Service and Spare Parts If you require service or spare parts please contact your local Service Centre by telephoning: 0990 929929 The address of your local centre can be found on the following pages; and also in your local telephone directory. Before contacting your local Service Force Centre make a note of the model and serial number, together with the date of purchase. The service department will require this information. [. . . ] Remove level adjuster (A) from base of product retaining small cup spacer which is located around the threaded portion of the adjuster. Remove the foot / hinge assembly (B) by removing screws marked (C). 7. Remove the door by lifting it slightly and carefully sliding it down off the top hinge pin (F) by removing screw (G) and transfer to the opposite side. Refit the door by carefully sliding it onto the upper hinge pin (F). [. . . ]