User manual AEG-ELECTROLUX EU1221U

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Frozen food must not be re-frozen once it has been thawed out. Manufacturers' storage recommendations should be strictly adhered to. [. . . ] Never use metal objects for cleaning your appliance as it may get damaged. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always insist on genuine spare parts. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. The appliance must not be located close to radiators or gas cookers. Avoid prolonged exposure of the appliance to direct sunlight. Straighten the safety washer (4) of the lower right hinge. Remove the screw (5) and the pivot (6) (Fig. For safety reasons bend the washer located under the left hinge (Fig. Remove the right door stop hinge (3-Fig. 6 Slide the refrigerator into the unit recess and fit the screws into the top bracket (Fig. 6). D585 6 4 5 For safety reasons, minimum ventilation must be as shown in the Fig. Attention: keep ventilation openings clear of obstruction. 50 mm D563 Fitting the handle Holes for fitting the handle on the opposite side are provided, with fixing screws already in place. Building-in Recess dimensions Height Depth Width 880 mm 550 mm 560 mm min. cm2 200 D526 The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. Fig. 5 50 54 0 P L H D240 Air is taken in through the ventilation grille at the bottom of the appliance, but an air outlet "gap", measuring 50 mm deep by 540 mm wide (Fig. 5), must be provided in the rear of the kitchen unit. This outlet gap must also be kept clear between the top of the unit and the ceiling. 33 USE This freezer has been marked with the symbol, which means that it is suited to the freezing of fresh foods, the conservation of frozen foods and the production of ice-cubes. The control panel max min A Fig. [. . . ] is shown on the rating plate; the freezing process takes 24 hours. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. [. . . ]