User manual AEG-ELECTROLUX EU1230T

[. . . ] Children should not be allowed to tamper with the controls or play with the appliance. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance should be serviced by an authorized Service Centre, and only genuine spare parts should be used. It is dangerous to alter the specifications or modify this appliance in any way. [. . . ] This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Location Place the appliance as far away as possible from sources of heat, e. g. radiators, heaters, direct sunlight, etc. . The best results are achieved with a room temperature ranging from +16°C to +32°C. Make sure that there is nothing at the back, at the top and at the bottom of the appliance to obstruct air circulation. For a more efficient operation of the appliance the minimum distance between the top of the appliance and other overhanging kitchen furniture, if any, should be at least 100 mm. One or more adjustable feet mounted on the base of the appliance make it possible to set it perfectly level. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 34 Changing the opening direction of the door Unplug the freezer before performing the following operations: Remove the ventilation grid (C-Fig. Remove the door from the upper pivot (A-Fig. Remove the pivot from the upper hinge (B), then mount it on the opposite side. 1) on the opposite side by using the screws previously removed. To do this, press it in the direction of the arrow. Introduce the plug into the hole left free on the opposite side. 3), reverse the direction of the handle. The unused opening direction is concealed by plastic plugs. Therefore, these plugs are to be mounted on the holes left free. D230 Fig. 3 Aligning the worktop of the appliance with the kitchen furniture The appliance worktop is aligned with the door. It can however be easily aligned to the kitchen furniture by proceeding as follows: unscrew the screws on the upper hinges that fasten the worktop to the appliance. Move the worktop to the desired position and tighten the screws again. B0646 35 Installation under the kitchen's work-top Open the door. Remove from the upper hinges the screws (F-Fig. 4) that fix the appliance's work-top. Push the work-top (G) toward the back of the appliance and remove it. [. . . ] In addition, if the freezer has been out of use for some time, before putting the products in the compartment let the freezer run for at least two hours on the quickfreeze setting. After this, reset the freezer for normal storage use. Avoid opening the door too frequently and when you do open it, leave it open only for as long as is strictly necessary. A word of warning about ice lollies: they should not be eaten straight out of the freezer as this might cause cold burns. [. . . ]